100A 100V 150V 200V Ideal Diode Module For Photovoltaic Solar Base Station

In comparison to the myriad of electronic components we encounter in the field of electronics, the diode is a relatively simple component. Fundamentally, a diode is a component that permits current to flow in a single direction and blocks it in the other direction.

Diodes allow current to flow in one direction without the effects of any impedance, while entirely blocking all flow of current flow in the other. Furthermore, there is a clear designation between these two states of operation.

As stated, the current flowing through a diode can only go in one direction, and we call this state forward-bias. Since the current can only flow in one direction (forward-bias), we unofficially think of diodes as one-way electronic valves.

If the voltage across a diode is negative, then no current will flow; thus, an ideal diode appears as an open circuit.

The conditions or states a typical diode can exist in are forward-bias or reverse-bias. In electronics, we define bias or biasing as a method of establishing a set of currents or voltages at different points of an electronic circuit to set proper operating conditions within an electronic component(s).

Although this is a simplified version of the answer, it is still fundamentally correct.A diode is an electronic component consisting of a P-type and N-type semiconductor material; we call the p-n junction.

It also has leads connected to these two ends that afford ease of implementation into virtually any electronic circuit.

Special Note:
1. This version is the latest optimized version. The module will not be burned if the positive and negative poles are connected reversely, which improves the safety of installation;

2. The ideal diode is a diode with ultra-low internal resistance as the name implies. The conduction voltage drop of ordinary diodes is more than 0.6V. The conduction voltage drop of an ideal diode is almost negligible.
3. The copper foil layer and aluminum base layer of the aluminum substrate PCB traces are insulated with a withstand voltage of 1000V, so there is no need to worry about breakdown problems. The thermal conductivity is 20 times faster than FR4 glass fiber, and can be directly attached to the large heat sink.
4. This ideal diode module cannot be used in rectifier circuits!
5. The waterproof potting module has a thickened radiator, which has higher heat dissipation efficiency and lower continuous current heating. It is suitable for modification enthusiasts!