car instrument panel mold making plastic injection molding machine

The small machine is integral and does not need to be disassembled and assembled. When lifting, the adjusting mode should be adjusted to the minimum die thickness.

The disassembly and assembly of the machine will be completed by the large crew of the injection machine manufacturer.

If the machine moves again in the workshop and there is no crane, the bottom of the machine needs to be padded with rolling wood.

Because the machine is heavy, it should be directed by a crane worker with lifting experience. Attention should be paid to the following items:

(1) Use powerful hoists and conveyors to lift machines (including cranes, hoisting equipment, hooks, wire ropes, etc.).

(2) If any hanging wire rope is in contact with the machine, cloth or wood blocks should be placed between the wire rope and the machine to avoid damaging the machine parts, such as the pull rod of the injection molding machine.

(3) Pay attention to the stability and level of the machine when it is lifted.

(4) The wooden block pads or pads can not be removed until all the unloading and handling of the machine have been completed.

All mechanical parts exposed to the air, such as piston columns, pull rods and template parts, are coated with anti-rust agents before they leave the factory. The mixture of lubricating oil and clean hydraulic oil on the bearing surface can produce a rust-proof film.

The rust-proof agent is applied to the part which is not in contact with the machine during operation, thus providing protection against corrosion and harsh environment for the machine. Remove the antirust agent when running unless it is really necessary, but do not use solvent to erase the antirust agent.