Active Member
|
[China]
Address: 36# Yuefeng Road Zhangjiagang City Jiangsu Province China
Contact name:JACKY
Zhangjiagang City Stelle Coating Equipment Co.,Ltd. |
|
|
Manual Castings Sandblasting Room Vacuum Sandblasting Chamber Air Sand Blasting For Derusting Remove Paint
Main features:
5.2.1 Sand Blasting Chamber
Chamber main body made of square tube and compound rock wool insulation board, framework welded by square tubes and lined by 6mm wear resistant rubber panels, safety doors and manual hinged doors on the side of blasting chamber.
Air supply outlet on the top, exhausting inlet on the bottom and air inlet on the other side of roof, this structure can efficiently prevent dust, enhance visibility and improve labors’ working environment. Grid plate and wear resistant protective plate on the top of blasting chamber. Safety lighting system on the pit.
Principle Introduction:
| No | Comparison item | Honeycomb wind circulation sandblasting room | Traditional mechanical circulation sandblasting room
|
| 1 | Infrastructure
| 0.5-1.2 m or no foundation, low construction cost. . | 2.5-4 m deep pit, high waterproof requirements, foundation construction costs are several times higher than pneumatic recovery.
|
| 2 | Abrasive | Abrasive sorting There is separate sand returning fan. The cyclone separator is used to sort the abrasive. The particle size can be adjusted accurately, and the dust is large.
| There is no separate return sand blower, and the suction pipe is used for vacuuming. The particle size of the abrasive cannot be adjusted, and the air volume of the dust is not easy to be enlarged, and the sprayed abrasive is not uniform;
|
| 3 | The over-all layout | beautiful, the floor space is small, and the installation is convenient. Since all the equipment are connected by pipes, the installation positions of each system can be installed at will according to the site conditions.
| Each transmission system needs to be closely coordinated, it is impossible to change the installation position, the floor space is large, and the maintenance is inconvenient.
|
| 4 | Abrasive accumulation in the sand return system Abrasives | remaining in the sand return system and fewer Abrasives
| remaining in the sand return system, such as screw conveyors, bucket elevators and other equipment will accumulate a large amount of abrasive
|
| 5 | Occupational safety and environmental protection | The overall sand-absorbing and dust-absorbing floor, the wind flow from top to bottom, the dust suppression environment, dust content, visibility, dust emission are better than the national standard.
| Because the underground material needs to be installed with sand conveying equipment, the suction method is generally sucking up. The wind or side suction forms a dusty environment with high dust content, low visibility, and poor working environment.
|
5.2.2 Sand Blaster
1 set of continuous spraying gun with USA CLEMCO technology .
● automatic control, and commands sand blasting or air blasting on the nozzle. Eliminates float ash by air blasting after sand
Blasting .
● steady and strong jetting force to guarantee uniform and high quality metal surface treatment .
● Temperature controlled protective mask
● Durable and efficient CLEMCO abrasive valve, efficiency, safety and long service life.
● Spraying guns sand blasting and air - jet switch adopt wireless remote control, with frequency stability, high feasibility, 100 meters control distance, low power consumption, high sensitivity.Workers are easier to operate and avoid the possibility of damage to the pipeline due to harsh conditions.
