4WE6 4WE10 series original rexroth 12v 24v solenoid directional control valve

product description

Working pressure of rexroth 4we6 Directional Valves is 32Mpa,the same as NG3 valve and Cetop3 valve.4we 6 directional valve are usually used for changing the oil flow direction of hydraulic power,hydraulic working system and industrial hydraulic system.

REXROTH proportional solenoid valve is a hydraulic control valve that can make the output oil parameters (pressure) with the input electrical signal parameters (current or voltage) changes proportionally. Through the change of electromagnetic "iron voltage to produce different sizes of thrust action on the broad core, so as to obtain continuous change of hydraulic pressure.

4/3, 4/2 4we rexroth Type WE directional valves take use of wet-pin DC or AC voltage solenoids.
Size 6 Hydraulic Solenoid Valve
Component series is 6X (60~69)
The maximum operating pressure is 350 bar
The maximum flow is 80 l/min-DC Voltage Solenoids.
60 l/min using AC Voltage solenoids.

specification

Features

1. Rexroth solenoid valve solenoid valve and all stainless steel: for strong corrosion medium must choose isolation diaphragm type. Neutral medium, also directly selected with copper alloy valve shell material solenoid valve, otherwise, there is often rust off in the valve shell, especially infrequent occasions. Ammonia valve can not use copper.

2. explosive environment: must choose the corresponding explosion-proof grade products, open air installation or dust more occasions should choose waterproof, dustproof varieties.

3. rect operated directional spool valve with solenoid actuation in high-performance design.

4. Wet-pin DC or AC voltage solenoids with detachable coil.

5. Solenoid coil can be rotated by 90°.

Attention!

The specified switching performance limits are valid for operation with two directions of flow(e.g. from P to A and simultaneous return flow from B to T).
Due to the flow forces acting within the 4WE6 Rexroth valves,the permissible switching performance limits may be considerably lower with only one direction of flow(e.g. from P to A while port B is blocked)!
In such cases, please contact us!
The switching performance limit was establised while the solenoids were at operating temperature, at 10% undervoltage and without tank pre-loading.