Active Member
|
[China]
Address: NO.258, Time Plaza, When Kary Street, Causeway Bay, Hongkong, P.R.CHINA
Contact name:Shine
DENTRUN(HK) MEDICAL CO., LTD |
|
|
NKS Type Best Price Ultrasonic Dental Air Scaler 4 Hole / 2 Hole With 3 Scaling Tips
Ultrasonic Dental Air Scaler Handpiece Nks Type 4 Hole / 2 Hole With 3 Scaling Tips
Feature
1. Brand New; Durable; 100% CE High Quality.
2. One Handpiece Plus 3 Compatible tips: S1 S2 S3.
3. Easily attachable to any 2-hole borden handpiece connector
4. SKU: JK-E-QD(N)-B-B2
Specifications
Available air pressure: 3.2 KG/c㎡
Sterilization: High-temperature (135 Degree) and High-pressure
repeatedly
Available Air Pressure: 2.5~3.5KG/c㎡
Air Pressure: 2.8KG/c㎡
Air Volume: 15~24L/Min
Sound Level: 65-68 dB
Net weight: 0.12kg
Gross weight: 0.15kg
Packing size: 170*80*30MM
Caution
1. The air supply must be free of moisture. The water supply must
be filtered.
2. Place the most priority of the patients safety
3. Do not exceed 0.28Mpa(2.9kgf/cm2)when setting the air pressure
at the dental unit.
4. If any abnormalities are found in use, stop using immediately
and contact your dealer.
5. Do not drop, hit, or subject to excessive shocl.
6. Check the vibration, noise and overheating outside of the
patient's mouth before initial use. If any abnormalities are found
in use, stop using immediatel and contact your dealer.
7. Be sure to stop the air supply, and replace the tip ro the
coupling joint.
8. Watch out the sharp point of the tip.
9. Do not use a spray lubricant. Limited air discharge orifice size
of the scaler forces the propellant pressure to build up inside,
and the scaler may fly off.
10. Do not clean or wipe the scaler with highly oxidized or acid
water or strilizing solution.
Installation
1. Holding the tip-end, turn clockwise and fasten securely tighten
with wrench.
2. Shout off the water supply. Adjust air pressure to 2.8KG/CM2
Adjust the water flow until a fine mist ejects from the tip.
Lubrication
Supply 2-3 drips into the drive air tube once or twice a day or
spray lubricant into inlet hole of handpiece for about two seconds.
Content
scaler handpiece * 1
work tips * 3
Wrench * 1
