Roller Feeder Metal Sheet Straightening Machine For Tinplate Die Stamping

Roller Feeder Metal Sheet Straightening Machine For Tinplate Die Stamping

In the actual use process, the roller feeder has extremely stable performance and extremely low failure rate. However, in the long-term use of the roller feeder, if the operation is not correct or the necessary maintenance and maintenance are lacking, the fault will still be quite a lot.

Therefore, during the operation and use of the roller feeder, the material thickness, feeding time, delivery distance and relaxation position of the feeder should be adjusted in strict accordance with the operating rules on the instructions of the Jinzhide roller feeder.

Then, after the inching test and the single-action test, the continuous production can be carried out. At the same time, in daily use, the maintenance of the feeder should be done regularly, so as to fundamentally eliminate the failure of the feeder and ensure its long-term stability. Continuous stamping production to maximize customer benefits.

In addition to the correct operation of the roller feeder, regular maintenance is also indispensable:

1. Before the roller feeder is running daily, it is necessary to carefully check the feeder first to ensure that there is no chipping or foreign matter in the gear contact part, the cross joint has no wear, the friction shaft contact surface is not worn, the pressure plate is not blocked, and The bolts (rocker screws, press springs) of each component are not loose.

2. After the press is changed, the adjustment screw on the mounting plate should be adjusted to the roller feeder to adjust the feeding height. The adjustment principle is slightly lower than the lower mold of the comparable mold, and the material cannot be introduced into the mold guide column first. Adjusting the height of the feeder, this method can easily damage the mold.

3. Before running the feeder, it is necessary to carry out the trial die after the normal operation, and then carry out continuous stamping and feeding. During the operation of the feeder, it is necessary to pay attention to whether the delivery distance is accurate and whether the material is skewed. If it is found that there is abnormal feeding, it should be stopped immediately for inspection and re-commissioning.

4. After the delivery of a roll of material is completed, it is necessary to stop the punching machine in time to avoid the punching machine accidentally puncturing the mold.

5, the roller feeder should be lubricated regularly (usually once a month), and the wear and tear of spare parts caused by long-term work should be contacted with Jin Zhide mechanical technicians for replacement.

Products:

Specification:
 

Straigtening performance:
 

*1:(Pneumatic):Option in case of pneumatic mandrel expansion is provi