Gysin Planetary Gearbox Options
Virtually any custom option will be given serious consideration.
Please send us your drawings and/or specifications. We will
do our best to comply accordingly.
Typical Custom Options include the following:
- Minimal Backlash Provisions.
- Alternate Materials of Construction.
(Stainless Steel, etc.)
- Mounting Adapters for virtually any drive motor design.
- Additional Stages for higher gear ratios.
(1 to 3 stages are standard. Up to 5 are available.)
- Alternate Output Shaft Designs.
(Spline, key-way, etc.)
- Alternate Mounting Configurations.
- Reinforced Bearings to withstand high radial loads.
- Pinions machined into customer supplied motor drive
shafts, when required.
- Pinion Gears mechanically secured to motor shafts upon
request. (Complete motors can be sent to us. We will drill
a hole through the pinion and motor shaft, and then secure
the pinion gear in place with a pin through the hole.)
- Alternate Lubricants in bearings and gearbox for
low and high temperature applications.
- Open Construction for Oil and Gas Applications, where
units operate submerged in high temperature and high
pressure hydraulic oil. Here the intent is for the oil to flow
through the interior to both provide lubrication and to
equalize pressure inside and out.
- Provisions for Sterilizing in an Autoclave.
(Common for medical applications.)
- FDA Approved Lubricants.
(Typical for medical applications. Also, would not
contaminate seawater if an underwater accident were
to occur.)
