Plasma Nozzle 220831 For HyPRO2000 Plasma Cutter Consumables

Plasma Nozzle 220831 For HyPRO2000 Plasma Cutter Consumables

plasma machine powermax45,powermax65,powermax85,powermax105 plasma consumables. plasma powermax65, 85, 105 plasma cutter consumables. powermax85 plasma torch consumables, 45A hyperherm nozzle 220941, 65A hyperherm nozzle220819, 85A hyperherm nozzle 220816, hyperherm electrode 220842, hyperherm shield 220817, hyperherm swirl ring 220857

Technical Support:

1, plasma cutting technology

Plasma cutting is the use of high temperature plasma arc heat to make the metal part of the incision at the local melting (and evaporation), and by the momentum of the high-speed plasma to remove molten metal to form a processing method of incision.

2, plasma cutting and flame gas cutting

Plasma cutting can only be effective as a conductor of metal - low carbon steel, aluminum and stainless steel are typical examples. In cutting low carbon steel, the operator will experience a higher speed, deeper cutting effect.

Flame gas is cut through combustion at high temperature, or by oxidation and cutting of metal. Therefore, the scope of its application is limited to the steel of this type can be used in the processing of black metal oxide technology. Metals like aluminum and stainless steel will generate oxide bound further oxidation. This makes the traditional flame gas cutting is impossible to deal with this kind of material. Plasma cutting, and is not dependent on oxidation treatment, so it can effectively cut aluminum, steel, and other conductive metal.

Cutting gun:

1) plasma generator, conductive nozzle, conductive electrode, gas distributor, ceramic, nozzle.

2) cutting gas air plasma arc cutting using compressed air as cutting gas.

3) selection specification including cutting current, cutting speed, gas flow rate and parameters.

The stability of plasma arc cutting machine has a direct impact on the quality of cutting. Plasma arc unstable phenomenon, will lead to uneven wound, and the accumulation of tumor and other defects, but also lead to the control system related components life is reduced, the nozzle, the electrode frequent replacement.