76mm Dia Conveyor Belt Drive Rollers For Electric Power Plant

76mm Dia Conveyor Belt Drive Rollers For Electric Power Plant

High Speed Belt Conveyor Vertical Side Guide Roll On Self Aligning Roller

The self-aligning roller is widely used in the matching of belt conveyors in mining, electric power, metallurgy, chemical industry, food, construction, ports, docks, etc. If the conveyor belt deviates, the frictional force relative to which side of the center of gravity will increase, under the action of friction, the end with greater friction will swing in the running direction of the conveyor belt. This automatic swing function Return the belt to the middle running route. This function is produced by the structure of the product itself, without the need for a special adjustment mechanism or other devices to adjust the belt, so the structure is simple, and only the running idler is caused to swing and adjust the deviation during the deviation adjustment, which avoids the belt. Damaged. The appearance size is the same as that of ordinary rollers, so there is no need to make any changes to the roller bracket and other parts, so it is extremely convenient to use.

During the operation of the belt conveyor, the flexibility of the roller is very important. If the roller is not flexible and the coefficient of rotation resistance is high, the entire belt conveyor system will have to pay a lot of power and consume a lot of electricity. Sometimes it will cause the tape to tear and the motor to burn out. In severe cases, it can cause a fire. Therefore, the selection of idlers with low rotation resistance coefficient (well less than 0.020) is an important part of the design and selection of belt conveyors.

How to maintain the sealing performance of the Impact roller?

(1) The labyrinth seals should be made of original parts, and should be put into the rollers during assembly, and should not be assembled together.

(2) For the sealing performance and use performance of the roller, it is forbidden to disassemble the roller at will.

(3) The normal service life of the roller is more than 20000h, and generally does not need to be repaired. However, according to the place of use and the size of the load, the corresponding maintenance date should be established, and the oil injection maintenance should be cleaned in time, and the floating coal should be cleaned in time. The rollers with abnormal noise and non-rotating should be replaced in time.

(4) When replacing the bearing, the opening of the bearing cage needs to be opened outwards. After the bearing is installed into the idler, the proper clearance should be maintained and it should not be crushed.

(5) During the use of the idler, prevent heavy objects from hitting the idler tube.