Industrial Cooling Tower/Cooling Tower
1. Type: Steel structure and concrete structure FRP casing.
2. Cooling tower of capacity for one cell: 800 to 4500m3/H,
3. Body frame for cooling tower: A. JBNG series: Made up by steel
bar, round and square steel pipe. All componentsare hot dip
galvanized or handled with other special embalmment. Thus it
isanticorrosion and high intensity.
4. Casing: Made of reinforced compound material. The body surface
is imported colorizedgel-coat surface, which contains ultraviolet
radiation absorbefacient.
5. Drive system: Use horizontal shaft drive gear reducer. For
easier maintenance, motor is fixed outside fan stack while oil
ruler outside fan stack.
6. Distribution system: Use distribution pipe fixed with advanced
gravitational nozzlein the world. It may work at low water supplier
pressure, sprinkle water equally, and never jam.
7. Sprinkling fill: Use high efficient PVC fill. The piece mould is
tested by authoritydepartment, compared to other fill, it has such
advantages as larger surface, small air resistance, good
hydrophile, large heat transfer coefficient,
8. Eliminator and louver: Use national advanced special
three-dimensional eliminator, impact of which is rather remarkable,
with drift loss of less than 0.005 percent.
9. Guarantee of cooling capacity: Designed strictly on GB
7190.2-1997 and advanceddesign idea in the world; Tested in Jinling
Thermal Performance Test Lab, whichis built on CTI standard.
Production is controlled and guaranteed by ISO9001
andISO14001.&
