3m Construction Wire Mesh Electro Galvanized Ladder Mesh Block

Electro galvanized 3m Length 10cm Width Extra Heavy paving Construction Wire Mesh

Construction Wire Mesh Introduction: 

Qijie Company Truss-Mesh and Ladder-Mesh are continuous lengths of joint reinforcement that are embedded into the horizontal mortar joints of masonry walls

Joint reinforcement has long proven to be necessary for superior performance of masonry wall construction, as it offers the following benefits:

Reinforces a variety of masonry walls

Greatly reduces cracking that can arise from thermal stresses

Enhances resistance to water penetration, as cracks are controlled

Increases lateral flexural strength

Bonds exterior and interior masonry wythes together in composite walls

Bonds masonry at intersecting walls and corners

Increases elasticity

Increases performance of masonry walls under various stresses

Fabricated in conformance with ASCE/ACI 530 building code requirements for masonry structures, and ASTM A 951 (standard specification for masonry joint reinforcement)

GAUGES:

Reinforcing can be STANDARD WEIGHT (9 ga x 9 ga), EXTRA HEAVY (3/16" Side Rods x 9 ga Cross Rods) or SUPER HEAVY DUTY (all 3/16")

AVAILABLE FINISHES:

Mill Galvanized

Hot Dip Galvanized

Stainless Steel

DIMENSIONS:

Packed 500’ per bundle (50 pcs. - 10' long)

Tri-Mesh, Twin-Mesh and Box-Mesh packed 250’ per bundle (25 pcs. - 10’ long)

Corners and Tees packed 25 pcs per bundle

MATERIAL : Iron wire & stainless steel wire 304/316
Qijie metal joint reinforcement products conform to:
ASTM A951 (Standard Specification for Steel Wire for Masonry
Joint Reinforcement)
Our products pass the testing of ASTM A951,We tested in USA .
Tensile Strength - 80,000 p.s.i. | Yield Point - 70,000 p.s.i. minimum
Zinc Coating:
Mill Galvanized coating: (0.1 oz/ft²)
Hot-Dip Galvanized after fabrication: (1.5 oz/ft²)
Wire Diameter:
9 gauge or 3/16ӯ
Side Rods and Cross Rods available in any combination of the above.
Cross Rods welded 16” O.C.
Block Size: Standard Sizes: 4” wall - 16“ wall.
Other widths available on special request.

Construction Wire Mesh Standard Specification:

* 4” wall - 16” wall
* Other widths available on special request
* (S) Standard: 9 ga. side rods x 9 ga. cross rods
* (EH) Extra Heavy: 3/16” side rods x 9 ga. cross rods
* (SHD) Super Heavy Duty: 3/16” side rods x 3/16” cross rods

*Tensile Strength - 80,000 psi
*Yield Point - 70,000 psi