Nema 17 Closed Loop Stepper Motor 440mN.M 18 Degree Stepper Motor

1. 8 degree Casun Closed Loop Stepper Motor 440mN.M 42x48mm Stepper Motor With Nema 17 Stepper Motor Controller

Nema17 Closed Loop Stepper Motor 440mN.m 1.68Amp with Encoder 

The Casun Closed Loop Stepper Motor you mentioned is a specific model with the following specifications:

Step Angle: 1.8 degrees per step
Holding Torque: 440mN.m
Size: 42x48mm
This stepper motor is designed to provide precise positioning and control. The1.8-degree step angle means that the motor will move1.8 degrees with each step. This finer resolution allows for more accurate positioning compared to motors with larger step angles.

The holding torque of 340mN.m indicates the motor's ability to hold its position when not in motion. This torque value specifies the maximum torque the motor can exert without losing steps.
 

Features:

• Bipolar or unipolar versions available

• Hybrid stepper construction

• Available in single or double shaft versions

• CE and RoHS approved

• Customizations on request

Motor Specifications

Operating Specifications

Motor

Step Angle: 1.8°

Maximum  Temperature :80°C maximum

Ambient Temperature: -20 °C to 50°C

Storage Temperature -20: °C to 100°C

Humidity Range (%) :85% or less, non-condensing

Magnet Wire Insulation :Class B 130 deg C

Insulation Resistance :100M Ohm at 500 VDC

Dielectric Strength :500 VDC for 1 min

Encoder 

                                                                                                            can customized

Voltage: 5 v

Output: A + A - B + B - 

Torque Curves 

Submodels

Download

If our standard motor cannot meet your needs,

we can customize the motor according to your needs

Customized content includes but is not limited to special shafts, winding parameters, installation dimensions, lead wires with special requirements, connectors, etc.

Options:
            Encoder          |               Brake           |              Gearbox            |           Shaft

Please click the "Get  a quote" button below to tell us your requirements.