75W 25kHz Diesel Common Rail Injector Tester Machine 220 Volts

Diesel Common Rail Injector Tester Diagnostic Tools

Why have to clean injector?

* When we turned off the engine suddenly, the gasoline which have been spray out can not be recycled. It would attached on the injector and combustion chamber walls.
* Gasoline is easy to volatile, but wax and varnish were stayed.
* Heat these wax and varnish day after day,they will be changed into hard coke.
* The hard coke will be produced more quickly and more thickly when engine work with poor quality fuel.

About Machine Details

WDF-GDI injector cleaning and testing machine is designed with wide voltage technology and is suitable for 110V and 220V voltage. It is combined with ultrasonic cleaning technology and microprocessor hydraulic control cleaning detection technology. Fuel pump oil supply simulates low, medium and high engine conditions, cleaning and testing the fuel injectors of the automobile; ultrasonic cleaning can simultaneously clean multiple injectors, which can effectively and completely remove carbon deposit for the automobiles injectors.

Features:

1. Cleaning hard coke from injector via ultrasonic and auto electronic technology;
2. Imitate working as vehicle's fuel system;
3. Backwashing;
4. Uniformity testing;
5. Fog detection;
6. Fuel injection quantity detector;
7. Tightness test;
8. Automatic cleaning mode;
9. Vehicle cleaning mode;
10. The minimum pulse width test.

Installation :

1. All equipment are delivered with 3 pin electrical cable, use the ground connection for equipment and operator protection.

2. Verify that test liquid level at 2.5L or at least between the range of two red lines. For a new machine, please fill 2.0~ 2.5L testing liquid. Never fill up the tank at its maximum capacity.

3. Fill up the ultrasonic cleaning tank with the liquid for injector cleaning. Liquid level should not reach 3 cm below the tank edge, in order to avoid liquid overflow on device. Take special care not to drop liquid on the equipment when filling up or emptying the tank.