Standardized Operationg Steps Before Automatic Flute Laminating
Machine
Before the paper mounting machine is produced every day, the
following eight preparations should be made:
(1) the captain should correctly understand the requirements of the
construction order before starting up, and check whether the
incoming samples and work orders are complete and consistent. If it
is a product with no sample and no construction order, it shall not
be produced, and the department head shall be notified in time. If
you can't fully understand the requirements of the paper mounting
machine construction sheet, you should ask the monitor and
supervisor clearly, and you can't make production based on
subjective assumptions.
(2) Check whether the products to be mounted are ready. If not,
report to the monitor and assist the monitor in handling the
products. Check the preparation of glue. To receive glue, the
requisition should be filled out, signed by the supervisor to the
warehouse, and the glue model should be clearly seen when receiving
it.
(3) The paper mounting machine must be oiled and lubricated before
going to work every day. Be careful, comprehensive and not missing.
At the same time, observe whether there is blockage in the oil
hole. Once found, it should be cleared and dredged.
(4) Mount the surface paper and the base paper on paper racks
respectively, and adjust the width of the surface paper and the
base paper, requiring the paper to be centered. When loading paper,
pay attention to that the grain of paper is perpendicular to the
roller. The backing paper shall be based on the bite of the watch
paper and the pull gauge, and the position shall be determined,
which shall not exceed.
(5) The adjustment of glue has a great influence on the paper
mounting machine, which generally depends on the water absorption
of paper. Paper with large water absorption needs more glue, and
vice versa. Too much glue makes it easy to make paper tape glue,
and too little glue makes it weak.
(6) Before the veneer machine is officially started, 20-30 pieces
of waste paper should be used to send off and try to mount it.
Check whether the bonding is firm, whether the paper mounting is in
place, and whether there are traces of glue. Until the quality is
stable and confirmed by the monitor and supervisor, the production
can be started.
(7) check whether the electrical switch, brake and other components
are flexible and reliable. If there is any abnormality, report it
to the team leader or supervisor, obtain it from the maintenance
department in time, and deal with it as soon as possible.
(8) pay attention to observe whether there is any abnormal reaction
on the paper pasting machine. If there is any abnormal noise,
abnormal action and local overheating of the machine, stop the
machine immediately for inspection. In case of unsolvable machine
and equipment problems, the team leader and supervisor shall be
informed, the maintenance sheet shall be filled out and submitted
to the equipment department for maintenance, and the fault
phenomena and fault positions of the machine shall be noted.
