Active Member
|
[China]
Address: NO 123 Suzhou Dadao East Road Suzhou Jiangsu China
Contact name:Tina
Suzhou Kiande Electric Co.,Ltd. |
|
|
Busduct Outgoing Sheath for Busbar Tap Off Unit for Conversion
Its used for the prevent the dust and Sundries entering the tap off unite
| Model | Hole Diameter | Max. Diameter for Wire |
| KD-KT4 | φ76mm | φ68mm |
| KD-KT3 | φ66mm | φ54mm |
Installation Guideline of Tap Off Unit (Plug-In Type)
There are two types of plug-in tap-off units :
1) Plug-in tap-off units without automatic clamping system .
2) Plug-in tap-off units with automatic clamping system.
Step 1: Open or remove the tap-off unit cover.
Step 2: Install the protection device in the tap-off unit.
Step 3: Remove the IP protection on the outlet of the run component.
Step 4: Prepare the output cable glands and connect the cables to the tap-off unit.
Step 5: Check that the protection device is switched off and carefully inspect the tap-off unit for tools and objects that may have been left inside the tap-off unit.
Step 6: Position the rear of the tap-off unit on the run component.
Step 7: Plug the tap-off unit into the run component.
Step8: Lock the tap-off unit on the run component using the locking handle located inside the tap-off unit
Step9: Secure the tap-off unit on the run component using the fixing mechanism.
Step10: Close the tap-off unit cover. The system and the load are ready to be energized.
