ERIKC 7135-654 delphi injector repair kit valve 9308-621c original nozzle L133PBD valve 9308Z621 for EJBR00501Z

FAQ: What does the term static means?

ERIKC Answer: If an ERIKC injector stays on all the time, 100% duty cycle, it is said to be static. Injectors should never go static because control of fuel delivery is lost and this can cause catastrophic engine failure. Static injectors, or 100% IDC is normally an indication that the injector is too small for the engine. Injector duty cycle should usually not exceed 80%. Once 80% IDC is reached a bigger injector should be installed.

In some instances low fuel pressure or a failing fuel pump can cause injectors to become static. On the other hand, there are some injectors that will go static if the fuel pressure is too high.

FAQ: What is an Injector’s Static Flow rate?

ERIKC Answer: Manufacturers rate fuel injectors by the maximum amount of fuel that they can flow in a given amount of time at a given pressure. This measurement is known as Static Flow Rate and is normally taken at 100% duty cycle and a fuel pressure of 43.5 PSI.

Example: At 100% duty cycle a 55 pound (lb) injector at 43.5 PSI of fuel pressure will flow 55 pounds per hour.

Injector Flow Rates are expressed in pounds per hour (lb/hr) or cubic centimeter per minute (cc/min). Given the same pressure 1 lb/hr = 10.5 cc/min.

To convert lb/ hr to cc/min, multiply by 10.5

Sometimes injector flow rates are expressed in milliliter per minute (ml/min)

1 ml = 1 cc

Example: a 220 cc injector = 220 ml injector