12VDC 3A current PWM control BLDC motor driver for sensorless BLDC
motor JYQD BLDC motor driver
Model number :JYQD-V6.7-12V
Operating temp.: -20—85℃
Operating voltage 12V
Cont.working current: 2A
PWM speed control :PWM frequency:1K-20KHZ; Duty cycle 0-100%
Analog voltage speed regulation :0-5V
Speed pulse signal output :YES
Application notes:
1. Confirm that the voltage and power parameters of the motor not
exceed the range of the driver board as specified. |
2. This BLDC motor driver board is used for 3-phase brushless
sensorless motor, but not suit for all 3-phase brushless sensorless
motors directly. If the driving effect is not good (such as
starting jitter, reversing, the motor noload working current is too
large, the speed is not stable, the efficiency is low, and can’t
start-up with load.) Customers can adjust the resistance and
capacitance of the driver board according to the actual situation
to achieve the best driving effect (see the attachment for how to
do the adjustment) |
3. JYQD-V6.7 driver board is bare board without housing and
heatsink. If the power of the motor below 60W ,it does not need to
add heatsink, It only needs to ensure normal ventilation and well
insulation. If the power of the motor more than 36W, it must add
heatsink like the diagram as below. |
Driver board diagram
Wiring diagram
5V -----Driver board internal output voltage
SC ---- Motor speed pulse signal output port, 5V pulse signal.
1. Control port
Z/F---- Rotating direction control ports. Connect “5V” high level or
no connect is Forward direction, connect 0 V low level or connect
to GND is reverse direction. |
VR ----Speed control port. Analog voltage linear speed regulation 0.1v
-5V, The input resistance is 20K Ohm ,connect with GND when input
PWM speed regulation, PWM frequency:1-20KHZ; Duty cycle 0-100% |
GND—Used for Drive board internal control |
2. Power port
MA ----motor phase A |
MB ---- motor phase B |
MC---- motor phase C |
GND----DC- |
VCC----DC + |
3. Use shielded wires if the drivers board has more than 50 cm
distance from the motor, otherwise it may lead to abnormal driving,
affecting the normal use.
4.Control port distance: 2.54mm,Power port distance:2.54 mm
5. Pay attention to the insulation between the driver MOSFET and
the heatsink or the installation plate.
Dimensional drawing
DOWNLOAD JYQD-V6.7 USER MANUAL