|
[China]
Trade Verify
Address: No.59 Xinhe Road, Shangmugu, Pinghu, Longgang, Shenzhen, Guangdong, China.
Contact name:Manfrid Lee
SHENZHEN SINOMATIC TECHNOLOGY CO., LIMITED |
|
Verified Suppliers
|
|
|
High-End Fashion Flap Barrier Gate With RFID Card Reader Turnstile Access Control System
Product overview
PRODUCT PARAMETER
| product size | 1200(Length)*330(width)*980(height)mm |
| Passage width | ≤550mm |
| material | AISI 304 stainless steel |
| swing material | Clear acrylic (10mm) |
| MCBF | over 5,000,000 |
| Power Supply | AC 220V/ 110V |
| power consumption | static state <50W,dynamic state <150W |
| Frequency | 50~60Hz |
| Unlock time | 0.2s |
| Throughput rate | 30p/m |
| Drive mode | DC motor |
| Infrared detection | included |
| weight | 75kg |
| Communication | TCP/IP, RS485(option) |
| working temperature | -30℃—65℃ |
| working humidity | <95% |
PRODUCT PHOTO
PRODUCT FUNCTION AND FEATURES
1. Problem-self-checking function.
2. Control board is with standard electrical interface for the integration of various access control terminal.
3. When power off, arm open automatically and power on again,
arm will be held automatically.
4. When valid card read and passenger passed, arm can be delayed to
close from 1-60s which can be set in the control panel.
5. Auto-reposition function: After card read, passenger not pass
within regulated time period, full-height turnstile will cancel
this passing right. And the regulated time period for passing can
be set by managers.
6. If passenger pass without card read or valid card read, flap
barrier will alarm untill passenger get back from the Swing barrier
and then take a valid card to be read for passing.
7. Direction display to guide passenger which direction is to go.
8. Anti-rush function: If there is no open signal, arm will be
holding tightly.
9. Double anti-clipping function: Photocell anti-clipping and
mechanical anti-clipping. When passenger is going through the
sliding barrier, photocell will detect out this situation and
will not close. After passenger passed, arm will close
automatically. During its reposition, if arm meets any obstacle,
arm will get back automatcially or stop working for a while with
very slight force.
10. Many options of working ways: Bi-direction card reading; One direction card reading and another no reading; One direction card reading and another freely. And single direction photocell controlled passing and close. Working ways can be set in the control panel.
