Remote Control Highway Drop Arm Automatic Barrier Gate Ac 100v To 264v With Solar Power

Remote Control Highway Drop Arm Automatic Barrier Gate Ac 100v To 264v With Solar Power

Motor controller diagram and functions

Important notes:

All the interfaces on this controller are only for non-electricity connection.

There are NC and NO inputs available for this machine. NC is recommended. To make it, just put the dip switch 1 to ON position. OFF position is for NO status.

1. NO/NC status adjustable, in dip switch 1, ON for NC, OFF for NO.

2. When power off, the boom will open automatically or stay closed; this is adjustable. In dip switch 2, ON is for automatic open when power off;

3. Automatic stop or automatic reverse when the machine meets external obstruction. In dip switch 3, ON is for automatic stop and off is for automatic reversing;

4. Auto closing function and the closing time is adjustable. Dip switch5,6,7,8 are for it and the delaying time is 1s,2s,3s,4s,5s,8s,10s,15s,20s,25s,30s,35s,40s,50s,60s.

5. The boom angle in up position adjustable, like 60 degree, 70 degree, 80 degree and 90 degree. And the dip switch is another independent one(1 2 switch).

6. Maintenance mode available, convenient for possible repairing and adjusting.

7. RS485 serial communication available for computer control.

8. Push button interface and remote control interface are available and separate.

9. Emergent stop input interface available.

10. Traffic light/alarm light interface

Program 1

The barrier gate can be controlled by two-key push button and an impulse will trigger the operation relay.

Connecting GND and COM, 24V with UP is for machine opening, 24V with Down is for machine closing. Other accessories interface input available, like IR sensor and loop detector signal.

Program 2

The barrier gate can be controlled by remote controller or GSM gate opener.

Connecting the antenna receiver GND to COM on the board, Remote-up is for opening and Remote-down is for closing.

If the remote control receiver is non-electric relay signal, connecting GND and COM first, the 24V connecting with Remote-up is for opening and 24V connecting with Remote-down is for closing.

Program 3

The barrier gate can be controlled by gate photocell(IR sensor) or loop detector for automatic opening and closing. There are other signal input as emergency stop and alarm signal. The connection is as program 1 mentioned.

Program 4

Boom-drop signal input: when the boom is crashed by passing vehicle, the barrier gate will stop to run with a warning output.

Specifications of Automatic Barrier Gate:

Product Dimension:

There is installation side for this barrier gate and it defines as the following picture.

A is left version, B is right version;

The user can change this installation directions.