Custom Straightening Wire Machine , 1 . 5 - 3mm High Speed Wire Straightening And Cutting Machine

1 . 5 - 3mm High speed Steel Wire Straighten And Cutting Machine

description

Is the position of the roll and straightening products direction as a point of view, two or three big initiative pressure roller, driven by motor to rotate the same, on the other side of the several small roller is driven pressure roller, they are against the rotating round rod or pipe friction of rotating rolls for products to achieve the required compression, these small roller can adjust the position simultaneously or respectively forward or backward, generally, the more the number of roller straightening products products after the higher precision is the roll bite into, continuously make linear or rotary motion, thus make the products in terms of compression bending under flattening deformation, finally achieve the goal of straightening

Features

Before starting, check that the hydraulic station of hydraulic oil of reducer transmission case whether gear oil filling up before starting the main motor, the examination of the Angle adjustment and the hydraulic system working pressure all lubricating points into the lubricating oil, check the mechanical transmission part of the operation condition to make the shipment wear labor insurance supplies, flexible operating personnel shall not leave after boot string in the hydraulic station of hydraulic oil temperature after reaching stable, the straightening roll up to the initial position of artificial material, steel tube will be delivered after the third of straightening roller straightening roller pressure on the clamping to start the main motor, go round steel tube straightening machine stop at the same time, stop the straightening straightening roller, the straightening roll up, send for inversion of straightening straightening of steel pipe, can pass on the reversal of the knob, make the host inversion and reverse straightening main motor stop, stop the straightening straightening roller, the steel tube was returned to the starting position, to repeat the next stop after straightening procedure instruction, total power close, can not arbitrarily change the program controller

parameters