Active Member
|
[China]
Address: NO.10.Lequn street Lepin town Sanshui district,Foshan city,Guangdong province
Contact name:Lee
Guangdong Yonglong Aluminum Co., Ltd. |
|
|
Mechanically Polished Aluminum alloy 6063 for aluminium corner profile joint
| Product | Mechanically Polished Aluminum alloy 6063 for aluminium corner profile joint |
| Material | Alloy 6060, 6061, 6063, etc. |
| temper | T5, T6,etc |
| Color | Different colors available (black, blue, green, champagne, bronze, golden, vermillion, etc.) |
| Surface treatment | Mill finish, anodized, electrophoretic coating, powder coating, thermal break, wood grain/wood-in-shift, etc. |
| Mould | Based on your drawing or use our mould free |
| Sample time | Usual practice: within 15 working days against payment |
| Usages | Windows, doors, curtain wall, solar panel, LED panel, heat sink, industry, etc. |
| Certified | ISO9001-2008 Quality System, |
Chemical polishing is a method of eliminating the grinding and etching of the ground by the selective dissolution of the surface of the sample surface by the chemical reagent. What are the main factors affecting the chemical polishing effect of aluminum profiles?
1. Aluminum is of low purity
When aluminum profiles are too low to be chemically polished, they can be either nickel-plated or chrome-plated.
2. The aluminum profile has dirt on the surface
The aluminum extruded material should be fully pretreated before entering the chemical polishing solution, and no stain on the surface of the aluminum profile.
3. The amount of phosphoric acid in the polishing solution may be too low
If there is no improvement and no other conditions, then a small amount of nitric acid or acid will be retried. You can adjust it in general.
4. The temperature of the polishing solution is too low
Polishing solution temperature range wide, but the temperature is very obvious influence the change of components of the solution, such as new solutions in the process with the lower limit of temperature or can obtain ideal polishing quality, this is because each component within the process specification, and the viscosity is smaller; When the solution using a certain of time, due to the change of the composition ratio in the solution, and the solution viscosity increased, often need to adopt the process specification limit temperature, sometimes even temperature reaches limit can not meet the requirements of polishing. Therefore, the temperature of the solution should be adjusted according to the actual situation of the ejection.
