Highly Glossy Anodized Aluminum Frame , Industrial Aluminium Profiles

Highly Glossy Anodized Aluminum Frame , Industrial Aluminium Profiles
 

The balcony aluminium window

In order to effectively use the front and rear balcony of the house, the residents of many buildings have expanded the housing area and sealed the balcony with aluminum alloy. With aluminum alloy closed balcony, according to the practical value is understandable, use steel window to close the balcony, it is a heavy weight, to the balcony bearing increased, 2 it is to brush paint each year and not beautiful, with wooden window closed balcony, it is not beautiful, the second is to brush paint, often for three is damp, dry repeatedly transform easy deformation. The aluminium material closes the balcony, the quality is light and beautiful, and does not need to brush lacquer, one-time investment is a little higher. Some users have a lack of knowledge about the balcony aluminium window, think that there is no big problem with an aluminum window on the balcony, which is less than the official aluminum window. Some people just want to find a personal security. Under the guidance of this erroneous thought, the users themselves relaxed the quality requirements, and thus did have many accidents in the whole country. In chongqing, in 1990, a rainstorm, a four-floor aluminum alloy closed on a balcony, was blown out more than 20 meters by the wind, smashed a passing car, smashed cars, and was compensated by the residents. There are countless blows to the Windows. Balcony aluminium and wall aluminium window which is stricter? The answer should be affirmative - the balcony aluminium window asks stricter. This is because it outstand the wall. The balcony a few surface by the force of wind load, closing on combined with the original design did not consider installing aluminium window, thus in the balcony guardrail and the balcony is no aluminium window begins to take root, than the original design is more strict in the aluminium window on the wall. Now the user closes the balcony, analuminium window should pay attention to the following aspects:

(1) do not use small sections and thin-walled aluminum profiles to make balcony aluminum Windows. Some of the cutting materials do not use formal aluminum window profile, but with square tube instead, the author saw 0.6 ~ 0.8 wall thickness, 50 x 50mm aluminium square tube enclosed balcony, this is very dangerous. Be sure to use formal aluminum window profile. If at the lower level with 70 series, the four layers above apply 90 series, the material section of more than 10 layers should be increased, the wall thickness of the profile is more than 1.3 mm.

(2) the strength of aluminum must conform to standard, at least feel the aluminum is very hard. A very soft aluminum profile will never work.

(3) the design should be reasonable, not to save aluminum, which is large and high. From the balcony guardrail to the top commonly is 1.72 meters ~ 1.78 meters, must not such high window fan. Must be in the upper part of aluminium window 400 ~ 500mm bright son (fixed

Window), below the push-pull window of 1.2 ~ 1.3m. The width of the push window should not be too wide.

(4) balcony closes aluminium window, consider the force of aluminium alloy outer frame cannot be too big, general closed balcony is not appropriate to use flat open window.

(5) the balcony aluminium window box and transverse box must be firmly fixed on the top of the balcony guardrail and balcony, rivets or fixed generally with a nail gun, don't be fixed on the grey paint on the wall and brick, must be fixed in the cement concrete. Never use a wooden block up and down to replace a nail gun.

(6) the aluminum is in the lower side of the road and is placed in the room. The short side is placed outside, and the small hole is punched in the short side, so as to drain the rainwater and prevent the rainwater from pouring into the room. The upper and lower slide roof and the gap between the guardrails are filled with cement mortar to prevent rainwater from entering the room.