Single Cylinder 40mm Rebar Upsetting Machine 7.5kw Rebar Threading Machine

Single Cylinder 40mm Rebar Upsetting Machine Rebar Threading Machine

Product Description of  Threading Machine

The rebar connection upsetting cold forging threading machine is mainly used for the construction of ribbed steel bar rolling straight thread head, it is an important equipment of steel bar connection.

The rebar cold forging upsetting machine uses the cold heading principle to make the steel end for plastic deformation, the diameter increased by 4 ~ 6mm, and then processing thread

Technical Parameters of Threading Machine

Features of Threading Machine

1. It can process steel bars with a diameter ranging from 12-40mm.

2. It greatly improves the tensile strength of the joint

3. High efficiency, can produce 300-500 pieces per machine.

4. Environmental protection, safety, economy, and low cost.

Instructions on the adjustment of the machine

1. Before processing, select the appropriate mold according to the diameter of the steel bar to be processed.

2. Replacing the mold: first remove the travel limit bracket, press the back button of the oil cylinder to the starting position, press the upward button of the oil cylinder to make the lower pressure cylinder rise to the starting position, remove the screws at both ends of the upper mold, The upper mold can be taken out in the middle, then the lower mold can be removed, and the end pressing plate can be taken out, the lower mold can be taken out in the middle, and the mold with the same diameter as the rebar can be installed according to the reverse operation of the above operation. Observe whether the upper mold runs flexibly, if not, remove the sliding surface for grinding.