Active Member
|
[China]
Address: F1 building, Filtration zone, Huwei Road, Xinxiang, Henan, China,453000
Contact name:Aliee
Xinxiang Uni-Sun Purification Equipment Co., Ltd |
|
|
10'' 5 micron Pre Filtration Melt Blown Sediment PP Water Filter /
water filter cartridge for RO systems
PP Melt Blown Filter Cartridge is using and intertwined of polypropylene resin without any chemical glues. The cartridges are glued at random to form 3D micro pore which will
make the cartridge 3 layers with fine fibers in surface and coarse fibers and deep filtration.
As the fiber and density form high filtration rating and pollutants holding capacity on diameter of filter cartridge, low pressure drop, gradual changing deep filtration
structure with loose outside and close inner, strong pollutants holding capacity, it can remove
contaminant effectively, such as suspended substance, particulate and rust, providing efficient
filtration and long service life.
technical parameters:
Applicable PH: 1-13
Working pressure: 0.6Mpa polypropylene skeleton,stainless steel
skeleton 0.8Mpa
Working temperature: Fiberglass 90 ℃, absorbent cotton string 120
℃, other cotton fiber, 90 ℃
Filter Length: 10,20 30 40 inches
Filter Diameter: φ65mm
Tangle cord specifications: PP line, cotton thread
Specification:
Construction Materials | Filter Media | Melt Blown Polypropylene |
| Inner core | PP or core less | |
| Seal Method | Thermal Bonding, No Adhesives | |
| O-rings/ Gaskets(only for 222,226,DOE) | Silicone/Nitrile/EPDM/Viton/Teflon | |
Technical Data | Micron Rating | 1.0, 5.0, 10, 20, 50, 70, 100um |
| Normal Operating Temperature | <50℃ | |
| Max. Operating Temperature | <80℃ | |
| Normal flow direction pressure | 4.0 bar(58 psi) | |
| Reverse flow direction pressure | 2.0 bar(29pci) | |
| Filtration efficiency | ≥ 80% | |
Cartridge Size | Outer Diameter | Φ 63(2.5'')/114(4.5) mm |
| Inner Diameter | Φ 28mm (1.10") | |
| Filtration area(m2) | 0.4 /10'' | |
| Length(based on DOE end cap) | 10’’, 20’’, 30’’, 40’’, 50'', 60'' | |
| pH | 1-13 |
feature:
(1)Continuous polypropylene wirewound filter element, all the
parameters was arrange by the computer ,which ensure the product
performance.
(2) Uniform working in full filter element/epoxy coated filter
(3) With stainless steel threaded coupling centers and interface
connector.
(4) The special design for backflushing .
(5) High-pollution capacity in full-length filter.
(6) Run a small resistance, strong adsorption.
(7) Provide different sizes filter element for powdex/ pre-filters.
(9) Large flow rate, smaller area, easily installation.
(10) Simple system.There is no pollution acid consumption and
waste, deal with the waste easily to protect for well environment.
(11)Low-cost investment , small pressure loss during the treatment
application:
Picture:
