Damisol®3042/200 Motor insulation paint

Damisol ® 3042/200

For a very stable, and it has a high reactivity of resin

For class H (180 ° C) heat resistance level

For the excellent and lasting mechanical properties

High flexibility, resin

An overview of the

Chemical composition: a single set of heat resistant unsaturated polyester resin.

Pale yellow transparent resin, using styrene as reactive diluent, after curing with good heat resistance, can be used in the top to the class H (containing H

Level) in the insulation of the system.

High reactivity of Damisol 3042 is a very stable one-component resin, can be used for various continuous dipping process (immersion, rolling and

Dripping leaching), can also be used for VPI process.

application

Used for various types of coil continuous impregnation (immersion, rolling and dripping leaching), especially suitable for high requirement of mechanical performance of the motor stator and rotor winding.

process

Resin 3042 can use either manual or automated immersed, rolled or dripping leaching equipment insulation treatment. Even in the absence of preheating

Cases, low viscosity with a groove in the resin good permeability. Equipment of the process parameters and the resin viscosity can undertake choosing according to the type of the motor.

3042 design and viscosity of the resin is 200 mpa. S, but can be used according to need 9117 diluent to be diluted to a lower viscosity, which can make it

Enough for impermeable of fine copper impregnated.

The curing conditions: 150 ℃ under 30 to 45 min (the temperature of copper wire).

Higher curing temperature or longer cure time to obtain higher mechanical strength and chemical resistance is necessary.

The resin should avoid being polluted and subjected to high temperature (< 25 ° C), it is necessary to viscosity test.

packaging

20 kg iron drum

200 kg drum

Storage conditions

Store in an airtight container and away from light, one-component resin under 23 ℃ the shelf life of at least 3042 for 6 months, at 15 ℃ under warranty

Less for 12 months.

If the resin in the paint storage tank, it is suggested that under the normal pressure (dry air or nitrogen) storage. In the process of storing resins is not completely full of the whole

A container is good for stability of the resin, recommend the filling rate of 70%.

Open the lid, stir regularly can make oxygen permeation into the resin, which can improve the applicable period.

Health and safety

Avoid any contact with skin and eyes;

Operating in a well-ventilated area, away from the flame;

Wear safety gloves and safety goggles.

Specific information can refer to material safety data form.

Test standard unit of resin

Physical properties of

Flash point 32 ℃ acuity

Gel time (120 ℃) min 3-5

Viscosity, Brookfield, 23 ℃) mPa. S 200-20

Shaw hardness D 88 ISO 868

Volatile organic compounds content % and IEC 60455-3 or less