three phase co capacitor TYPE FAdd time:2015-10-13
Contact phone:086-024-67987981
BKMJ-YF series cylindrical low voltage shunt capacitor
Product introduction
Our products are mainly used to save energy and electricity, in the
power system, the use of energy to improve the effective power,
reduce reactive power losses, reactive power compensation (power
factor for low voltage equipment is more positive and voltage
waveform improvement). The special injection process of the metal
film, the special injection process, the structure of the
cylindrical shell.
Characteristic
BKMJ-YF series cylindrical low voltage shunt capacitor is a new
technology which is developed by our company. It fills up the gap.
The capacitor is used in the internal structure and
explosion-proof. The mechanism of the new design concept, which
makes the capacitor smaller, lighter, safer and longer life.
High reliability and life expectancy of 100000 hours.
??????????????????????????????????????????.
The terminal is novel and easy to combine with the capacitor. For
example, the capacity of any 15 multiples can be combined with
15Kvar, and the capacitor with 10Kvar and 12Kvar capacitors is used
as a 22Kvar.
The volume and weight of the product is greatly reduced, which is
equivalent to the 1/3 of the old product.
? beautiful appearance, easy to install, aluminum shell, never
rust.
? the capacitor unit does not contain oil, liquid oil casing,
combines the advantages of oil immersed capacitor and dry-type
capacitor.
Use
Mainly used in low-voltage power distribution system, for improving
power factor.
Reference standard
National standard GB12747-2004 American Standard: UL810-1998
International standard: IEC60831-1.2-1996 (International Electrical
Commission Standard)
Performance index
Rated voltage: 200V, 220V, 250V, 260V, 280V, 400V, 415V, 450V,,
480V, 525V, 690V, 750V, 780V, 230V
Rated frequency: 50/60HZ
Capacity range: 1Kvar to 45 Kvar
Capacity accuracy: 5%
Three-phase unbalance: less than 1.1%?
Dielectric loss: Kvar = 0.3W/?
Dielectric loss tangent? < 0.1% (frequency Un.20 C)
Test voltage: between the poles: 2.15Un/10S polar shell:
3000VAC/10S
? internal connection: delta type or Y type connection
Condition of use
Working environment temperature range: minimum -40, maximum +60;
The relative humidity is less than 90%?;
Altitude: less than 2000m?;
? current: less than 1.3In (In rated current)
Over voltage: 1.1Un long term; 1.15Un is no more than 8 hours per
day; 1.3Un is no more than 1 hours a day;
Reliability and life
60000/5000 hours of operation under the rated voltage and nominal
category, the product failure is less than 6%/0.5% (1PPM hours) to
meet the EIA-456-A standard of the American electrical industry
association.
Sealing: 2 + 3 C 80 hours without leakage.
Life: under normal operating conditions, life expectancy reached
100000 hours
The following factors will affect the service life of the
capacitor.
At 1, the use of working conditions than under the conditions
worse, especially high temperature, long time overvoltage.
At 2, the grid harmonic component is bigger when.
= 3, switching too frequently.
? note: if beyond using the above conditions or have special
requirements of life, the customer is in the order must explain,
our engineers will take some technical means for the customer
design the most suitable products
Safety of capacitor
Self discharge performance: capacitor must have a built-in
discharge resistance, so that the capacitor from the power grid,
the voltage drop to 50V following 3 minutes, will not cause damage
to personnel and other equipment and devices.
Explosion proof performance: the capacitor in the failure occurs,
at least should not happen combustion or explosion. The most ideal
explosion-proof performance is when the capacitor failure, the
capacitor is only open circuit, automatic from the power grid.
Insulation performance: the terminal and the shell should be able
to withstand the voltage of 3000VAC, can not have leakage occurs.
Note
Cylindrical capacitor for roof explosion-proof structure, wiring
terminal capacitance is strictly prohibited with copper, aluminum
row connection, must use the soft copper wire
Three phase capacitor
Generally divided into delta type (690VAC), Y (690VAC), Mitsubata
Ko leads. The different ways of extraction are: 250# three, A, B
and F terminals.
On one: single-phase capacitor250#
The next: three phase co capacitor TYPE A
[return list]