Ruixin Energy Equipmnet |
Verified Suppliers
|
|
5.5 Inch Nickel Alloy Wireline Tubing Broach For Remove Rust
Wireline Tubing Broach Gauge Cutter Wireline
I. Overview:
The conical scraper is a tool used to hang any natural obstruction
cone in the well or to reshape the tubing with a small amount of
deformation. The whole cone can hang up the obstruction of about
4mm.
The Tubing Broach is used to remove burrs in the tubing left after perforating and broaching through the restrictions in the tubing. Tubing Broach is also used to remove scale, rust etc, from tubing I.D.
II. Product Specifications:
Max. O.D. (in) | F/N. O.D.(in) | Top Connection |
---|---|---|
1.50 | 1.375 | 15/16 - 10 UN |
2.00 | 1.375 | 15/16 - 10 UN |
2.50 | 1.375 | 15/16 - 10 UN |
3.00 | 1.750 | 1-1/16 - 10 UN |
5.00 | 2.313 | 1-1/16 - 10 UN |
5.50 | 2.313 | 1-1/16 - 10 UN |
Conical scrapers are available in various specifications according
to customer requirements.
III. Structural characteristics:
The oil pipe shaper is connected by the main body, the scraper and
the pressure cap. After the pressure cap is connected with the main
body, it is supported by nails (see the attached picture for the
specific structure).
There is a vent hole on the body, which is used for venting or
draining liquid during use, so as to prevent any end from being
held back, causing difficulty in use or accidents.
The scraper is a shuttle type with small ends and a large middle,
which is used to scrape obstacles up and down the shock cone, and
can scrape downward or upward.
IV.Precautions:
The conical scraper can only be used to scrape a certain amount of
obstructions. When the obstruction of the tubing is too thick or
the tubing is severely deformed, other tools should be considered.
Welcome to contact us at any time.