|
[China]
Trade Verify
Address: Room 1901, Block A, Saigao District Building, Feng Cheng Five Road, Xi 'an Economic and Technological Development Zone, Shaanxi Province
Contact name:Selina Qiang
Ruixin Energy Equipmnet |
|
Verified Suppliers
|
|
|
Custom Slickline Wireline Running Tool X Running Tool
I. Overview:
The X-type running tool is a special tool for putting X/XN-type
lock cores. It can selectively put the fluid control device with
X/XN-type lock cores into the X/XN-type seating joints in the well.
II.Technical parameters of common specifications:
| Nominal Size | Actual OD | Fishing Neck | Top Connection |
Bottom Connection
| |
| 1.5″ | 1.41″ | 1.188″ | 15/16″-10UN |
3/8-16UN″
| |
| 1.625″ | 1.593″ | 1.188″ | 15/16″-10UN |
3/8-16UN″
| |
| 1.875″ | 1.75″ | 1.375″ | 15/16″-10UN |
1/2-13UN″
| |
| 2.313″ | 2.175″ | 1.75″ | 15/16″-10UN | 5/8-11UN″ | |
| 2.75″ | 2.718″ | 2.313″ | 1-1/16″-10UN | 2/4-10UN | |
| 2.813″ | 2.72″ | 2.313″ | 1-1/16″-10UN | 3/4-10UN | |
| 2.875″ | 2.938″ | 2.313″ | 1-1/16″-10UN | 3/4-10UN | |
| 3.313″ | 3.406″ | 2.313″ | 1-1/16″-10UN | 1-3/8-12UN | |
| 3.813″ | 3.890″ | 2.313″ | 1-1/16″-10UN | 2-1/8-12UN | |
III.maintenance:
1. After the tool is disassembled, check the damage of each part
and replace the damaged parts.
2. When assembling, a thin layer of grease should be applied to the
thread surface.
3. After assembling, put the protective wire on the thread of the
salvage neck connection and mark it for later use.
Welcome to contact us at any time.
