Home Companies Jinzhou City Shitan Machinery Equipment CO. LTD.

High Speed Pneumatic Drilling Machine Customized Depth St 180 Meters

Contact Us

[China]

Trade Verify

Address: Xiaoshang Village, Yingli Town, Jinzhou City, Hebei Province, China

Contact name:Anna

Jinzhou City Shitan Machinery Equipment CO. LTD.

Verified Suppliers

Trust
Seal
Verified
Supplier
Credit
Check
Capability
Assessment

High Speed Pneumatic Drilling Machine Customized Depth St 180 Meters

Country/Region	china
City & Province	jinzhou hebei

Product Details

High Drilling Speed Customized Depth ST 180 Meters Pneumatic Drilling Rig

ST 180 Pneumatic Drilling Rig introduction

ST 180 is a type of light weight, high efficient, multiple functional drilling hole equipment. Which is equipped with advanced structure, easy to handle,high efficient, durable using etc , widely used for drilling well, farming irrigation well,geothermal air conditionhole and other usage well hole, especially suitable for water intaking in moutainnous area and rock layer.

ST 180 Pneumatic Drilling Rig Tech Data

Item NO.	ST-180	Air consumption(m³/min)	17-31
The Weight(T)	4.5	Equipped capacitor(Kw)	55
Dimensions(mm)	380015502350	Swing speed(rpm)	45-65
The hole diameter(mm)	140-254	Swing torque(N.m)	3200-4600
Drilling Depth(m)	180	Drill pipe diameter(mm)	76 89
Once-time advance length(m)	3.3	Drill pipe length(m)	1.5 2.0 3.0
Walking speed(Km/h)	2.5	Rig lifting force(T)	10
Climbing angles(Max.)	30	sopporting Power	29m3/min 23BAR AIR COMPRESSOR

ST 180 Pneumatic Drilling Rig Features

1. Walking device: Walking motor is equipped with gear box, durable and long life;

2. Hydraulic oil pump: parallel gearbox design with separate oil pump units, sufficient power supply and reasonable distribution, unique hydraulic system design, simple maintenance and low cost;

3. Power head device:gearbox is cast in one piece, dual motors provide power, large torque, durable, and low maintenance cost;

4. Drilling rig chassis:professional excavator chassis, durable, large load-bearing, wide chain plate, little damage to hard roads;

5. Lifting force: Adopting the designed composite boom, the boom is small in size, long in stroke, double
cylinder lifting, and the lifting tonnage is large;

ST 180 Pneumatic Drilling Rig Drilling Attentions

1. The operation of water well drilling rig must be completed by personnel who are healthy, have corresponding knowledge and have operation certificate;

2. The water well drilling rig shall not operate without care;

3. When the water well drilling rig does not use the hydraulic system, the switching valve of the pipe screwing machine of the water well drilling rig shall be placed at the "oil pump unloading" position;

4. When pulling the speed change handle, first cut off the clutch, and then change the gear after the gear stops rotating to avoid damaging the gear, and pay attention to fixing the handle;

5. When closing the clutch, it shall operate stably. It is forbidden to open and close violently to prevent the clutch from being half engaged;

6. After the chuck suddenly loses pressure due to accidents (such as loss of power, failure of oil pump or other mechanical and hydraulic accidents), the drill pipe or drilling tool shall be stuck in time;

7. When the water well drilling rig moves to the front limit position, it is allowed to drill or lift after tightening the lock nuts of the front and rear pressing plates;

8. Pay attention to the working condition of each pressure gauge at any time during operation, and handle it in time if there is any abnormality;

9. Always pay attention to whether there is abnormal noise or high temperature at each moving part; Problems found shall be handled immediately;