ZMP1104 PLC Electro Pneumatic Trainer Pneumatic Workbench
Pneumatic Training Kit
1. Structure
PLC Electro pneumatic trainer is designed for “hydraulic and
pneumatic training”, it meets modern pneumatic transmission
requirement. Students can learn basic pneumatic circuit control
knowledge, and practice hand on ability. Pneumatic trainer combines
electrical and mechanical transmission knowledge.
Through this trainer, students can master pneumatic components
structure, pneumatic circuit control theory, pneumatic circuit
design, and hand on ability for pneumatic trainer.
Add PLC module than ZMP1103.
2. Introduction
1. Workbench has 4 wheels, it is suitable for move and
installation. 2 wheels can be lockable. It use aluminum panel, the
distance for slot is 25mm, there is quickly plug in and plug out
sockets under components, students can plug components on aluminum
panel easily.
2. Every pneumatic component is an individual module, it has
quickly plug in and plug out sockets, can put in aluminum panel and
build pneumatic circuit.
3. Use stainless air compressor, running has low noise, it supply
good environment for training.
4. Pneumatic circuit use quickly plug in and plug out leads, it is
suitable for students to build pneumatic circuit. Students can
combine theory to practice, and practice hand on ability.
5. Add electro pneumatic components than ZMP102.
3. Basic structure
Pneumatic control experiment workbench including experiment
workbench, experiment shelf, pneumatic components etc.
Pneumatic components and real equipment: air filter, decrease
pressure valve, service unit, hand-operated direction valve,
pneumatic control direction valve, strike valve, check valve,
throttle valve, exhaust valve, single acting cylinder, double
acting cylinder etc.