ADSL Electronics Didactic Bench Educational It Cabling Trainer 3.68cbm

ZM5129A IT Cabling Trainer Building Automation System Training Educational Equipment Didactic Equipment College Equipment

I.Training purpose

This experimental training device can make students understand and practice the components, function, composition and principle of integrated wiring and computer network system.

It can carry on the transfer demonstration of data network, voice network and cable television network of integrated wiring, carry on installation, linking, operation and use of kinds of equipments on data network, such as ADSL, fiber optical transceiver, optical fiber box, network switch, cable wire wrapper distribution frame and information module, carry on installation, linking, operation and use of kinds of equipments on voice network, such as stored program control exchange, distribution frame, module and telephone set, carry on installation, linking, operation and use of kinds of equipments on cable TV network, such as signal source, cable TV amplifier, cable TV distributor and television, carry on design and linking of kinds of circuits, identification and installation of the structure of the component, linking every part through circuit diagram, designing and installing a simple application system and so on through the computer network, voice network and cable television network, it can realize the exchange with external information, carry on kinds of comprehensive trainings about networking with other system experimental training devices of wiring series.

The experimental device let students carry on the judgment and the disposal of line fault, the judgment and correction of the program set error.

2. Technical specification

Working voltage: single phase three wire 220V±5%50Hz
Whole machine capacity: ＜200W
Boundary dimension: 150×70×180cm3
Safety protection: it is equipped with electric leakage automatic protection device and ground protection.
Fault setting: fault setting module can carry out controller setting and the fault setting and shooting of hardware circuit.

3. Training project

Training one: the understanding training of cabling system and computer network system component, content and principle.
Training two: the basic function demonstration and operation training of cabling system and computer network system.
Training three: the understanding and building of working area subsystem
Training four: the understanding and building of horizontal cabling subsystem
Training five: the understanding and building of management subsystem
Training six: the understanding and building of vertical main line subsystem
Training seven: the understanding and building of equipment room subsystem
Training eight: the using and setting operation training of router
Training nine: the installation and using operation training of wireless network card
Training ten: the understanding and building operation training of local area network
Training eleven: the marking of voice jumper
Training twelve: the understanding and programming of SPC exchange
Training thirteen: the understanding and system building of voice network
Training fourteen: the understanding of cable television network
Training fifteen: the judgment and treatment operation training of wiring fault
Training sixteen: the connection training of specified wiring
Training seventeen : design and install a simple application system