24VDC Servo Motor Parking Lot Security Gates Planetary Gear IP54 High Precision

DZ-138 traffic barrier gate specifications:
 

 
 
Service Items
 
1. Two year’s free servicing is supplied (not including the arm and remote controller). In the condition of

complying with the operating instruction, without the unauthorized maintenance of the parts and the machine

have no obvious mechanical damage, we will provide a quality assurance for the barrier gate product from

the date of use for a period of two years or from the date of shipment up to three years including all mechanical

and electronic components other than special consumables.
2.Lifetime charged servicing is offered.
3.Technology servicing is supplied.
*The following situations are charged for servicing (or replacement):
1.Broken by wrong installation;
2.Broken by improper voltage;
3.The surfaces of the system destroyed by wrong installation or use.
4.Broken by natural disaster.
5.Overdue.
6.Servicing items out of the promises.

Interchange Instruction for Arm directions

The product direction can be interchanged, divided into 6 steps.

Step 1: remove the M8X20 inner hexagonal screw,take out the machine core;

Step 2: remove the electrical supporting plate from left side to the right side;

Step 3: remove the M10*30 fixed screw on the boom tray (see figure 1);

Step 4: using the M14*150 screw to pull out the boom tray head(see figure 2);

Step 5: install the boom tray head from the original left to the right side,or the original right to

the lest side;

Step 6: put the machine core back into machine case, fixed the M8*20 hexagonal screw,

direction interchange is completed, no need to adjust other Settings.

Program 1

The barrier gate can be controlled by two buttons and a short time signal impulse is enough to open barrier gate.

Wiring Connection: turn on the GND and COM,

Opening: turn on the 24V with UP

Closing: turn on the 24V with Down

Additional safety devices can be connected to the infrared signal input, vehicle detector signal input (loop detector).

Program 2

The barrier gate can be closed and opened by remote controller

Wiring Connection: connecting the receiver GND(COM) to COM of controller Remote-up is for opening and Remote-down is for closing.

Opening: connecting the receiver’s up level signal(5~24V) to the remote-up

Closing: connecting the receiver’s down level signal(5~24V) to the remote-down

Additional safety devices can be connected to the infrared signal input, vehicle detector signal input (loop detector).

If remote control receiver is non-electric relay signal, connection as bellows:

Wiring Connection: turn on the GND and COM,

Opening: turn on the +24V with Remote-up

Closing: turn on the +24V with Remote-down

Additional safety devices can be connected to the infrared signal input, vehicle detector signal input (loop detector).