Chongqing Tongrui Filtration Equipment Manufacturing Co.,Ltd |
|
Used Motor Oil Recycling Distillation plant can regeneration black engine oil to base oil
Attn:Marian Tan
HP:+86 15923000154
This technology is different from the traditional distillation
process with sulfuric acid,it is also different from the current
hydrogenation technology. The process of this technology is:
Catalyzing treatment of waste lube oil (including gasoline engine
oil,diesel engine oil ect. almost all sorts of recyclable waste
oil), and then distill to new lube base oil. The oil will not mean
to oxidate and change color, no odour. The residues can be used as
fuel, it will not make secondary pollution. This technology is high
automatic, the operation is simple, no complicate operation
control, easy to learn and understand, low labour intensity, 1-2
persons are enough and no special requirement.
The used oil is mixed with catalyst in chemical treatment tank,
then it is sent to distillation kettle to have it circulated and
heated, while the temperature increasing, the oil gas is distilled
out and cooled in to liquid through three stages cooling, they’re
separately stored in water, gasoline/diesel, light lube oil, heavy
lube oil receivers. The noncondensable gas will be sent to the
furnace of boiler to have it burned and discharged after pass
through waste gas disposer to ensure “zero “discharge of waste gas,
The residues can be utilized as fuel to avoid pollution from it.
Features:
1. Easy to operate, low operation cost
2. Environmentally friendly, without secondary pollution.
3. The machine can recycle gasoline oil, diesel oil, engine oil, rubber oil and other lubricant oil to clean oil.
4. High quality refined oil, no any discoloration caused by oxidation, no any bad smelling.
5. Low cost contain:
1) only need the catalyst chemical, the cost is less thanUS$30 to refine one ton waste oil.
2) Heat consumption: 105kcal per ton waste oil
3) Power consumption: 40Kwh to recycle 1 ton waste oil
6. High degree of automation.
Recovery Rate:
Component | Percentage(%) |
water | 1.5% |
Gasoline/diesel oil | 7% |
Light Lubrication oil | 42% |
Heavy Lubrication oil | 43% |
Residue | 6.5% |
Total | 100%
|
Treated Oil Analysis (take the waste diesel engine oil for example)
Item | Heavy Lube oil | Light Lube Oil |
Appearance | lucidity | lucidity |
Color ≤ | 1.5 | 1 |
Viscosity (40°C)mm2/s | 49.57 | 26.86 |
Viscosity Index ≥ | 96 | 95 |
Anti-oxidation 150°C,min ≥ | 180 | 180 |
Deemulsification,54°C | 5min | 5min |
Flash Point(Open)°C ≥ | 228 | 224 |
Pour Point °C ≤ | -12 | -16 |
neutralization value (mgKOH/g) ≤ | 0.02 | 0.02 |
1. 1-2 years quality guarantee;
2. Technical consult and mutual discussion
3. Engineers available to go abroad for installing and commissioning machinery
4. Free training for machines installation and operation of the staffs
5. Full set of Manual booklet in English Version
6. If there is something wrong with the equipment, seller should give a response and provide the solution within 24 hours.
7. If there is technological innovation, seller should guide the customer to upgrade.