Please click here to buy this product directly
ECU Flash Reprogramming DVD For Toyota
Language: English
Quantity of CD: 1DVD
Date: 12.2009
It is possible to permanently damage the ECU(ECM/PCM) during the
falsh reprogramming process.You must read and understand the
following precautionary information before proceeding with
reprogramming.
Note: It's only a programming DVD, should be used together with
allscanner IT3.
You can minimize the risk of damaging an ECU by understanding the
following precautions:
1. Battery must be fully charged and in good condition. BATTERY
VOLTAGE MUST NOT FALL BELOW 11.4 VOLTS OR RISE ABOVE 16.0 VOLTS
DURING THE REPROGRAMMING PROCESS.
2. All electrical accessories must be turned off and electrical
loads must not be altered significantly during the reprogramming
process (i.e. audio system, air conditioning system, interior
lighting, daytime running lights, etc)
3. The engine compartment hood must be open and under hood ambient
temperatures must not exceed 158ºF
4. Scantool/J2534 interface cables must be in good condition and
connections must be electrically sound prior to beginning
reprogramming (see TSB SS004-01, "ECU Flash Reprogramming Error
Message" for more detail).
5. Do not disconnect the scantool, J2534 interface or PC during the
reprogramming process; FAILURE TO FOLLOW THIS INSTRUCTION WILL
RESULT IN PERMANENT DAMAGE TO THE ECU.
6. Do not allow the PC running J2534 Calibration Update Wizard
software to go into standby or hibernation modes during the
reprogramming process; Failure to follow this instruction will
result in permanent damage to the ECU.
7. Do not cycle the ignition switch off during the reprogramming
process except where instructed to do so by the Calibration Update
Wizard or scantool software.
8. For ECUs that have more than one CPU to be reprogrammed, you
must COMPLETE ALL CPUs before returning the vehicle to service.
9. To ensure stable battery voltage during this process, it is
acceptable to connect a battery charger to the vehicle prior to
beginning the reprogramming operation. Charger must be set on "low"
charge rate and voltage must be maintained within the 11.4 volt to
16.0 volt window for the entire reprogramming process.
10. Set the parking brake for this operation
In addition to the above mentioned precautions, it is important to
read the specific TSB associated with the reporgramming event you
are reprogramming. Certain vehicles require removal of fuses to
prevent accessories from energizing during the reprogramming
process. Failure to follow the specific directions in the
applicable TSB for vehicle you are reprogramming can result in
permanent damage to the ECU.
Shipping Method and Delivery Time:US, UK, Czech and Russia Warehouse Shipping: 3-5 working days. Fast Delivery & Tax Free.
US Check:
Ship from USUK Check:
Ship from UKEU Check:
Ship from CzechRussia Check:
Ship from RUDHL Shipping: 3-5 working days. Usually we declare a lower value on DHL invoice
to help with customs clearance. If address belongs to remote area,
customer will need to pay remote handling cost or we can change to
ship by EMS. Please remember to leave message if you have any
special requirement.
Yanwen Express: 7-10 working days. No Tax or remote cost for European Countries.
Standard Post: 7-15 working days. To South America and Africa countries it may
take 20-25 working days. Customers can tick Express Shipping
Service to ship by DHL.