Language: English Only
How to Update 468 KEY PRO III Third Generation? 1 install the driver
2 open the upgrade program selected com port
3 open the file in the upgrade program (upgrade v1.02 New. Bin)
4 the upgrade button will turn black after you click on the
electrical source, just waiting until walking a scroll bar
5 PCS prompt upgrade success
1.Turn on the Left switch of 468 KEY PRO third generation, after turn on it, the main interface pops up.
Then click “COPY”. "copy46"
2. Click "CMT46 collect" Upper left corner of the screen.
3. This page is a copy of the ID46-chip page, now it is copying
ID46 chip.
3.1.Put the original chip vertically into the bottom right
corner of the hole, click on " read UID". Note: Do not going to be
flat on the hole nearby, this is not easy to read information
inside the chip.
3.2.Put the new key vertically into the bottom right corner of the
hole, click on "Conf ig". Note: Do not going to be flat on the hole
nearby, this is not easy to read information inside the chip.
3.3.Use new car key collect information in car, first of all, take
a key blank, put the new key into the key blank, insert the car key
hole, four consecutive starts,each time interval of 3-5 seconds
3.4.Put the key which already collected information vertically into
the bottom right corner of the hole, click on "read". Screen will
appear a set of "random number" and "signature".
4.After crack Original key , put the original key hole vertically
into the bottom right corner, click on " crack", the screen will
display the progress of the original key crack.
5.New key copy. Put the key which already collected information
vertically into the bottom right corner of the hole, click on
"Copy". Screen will display "copy successful" message.
6.If in the process, chip key copy failed, put the key into bottom
right corner of the hole, click on "Initialize", restart again from
the first step.
Packing List: