High Frequency Small Size of Ultrasonic Cutting Machine for
Film/Rubber Material
Specification:
Model | HS-C40 |
Frequency | 40KHZ |
Output Power | 100W |
Generator | Analog generator, 155 x 265 x 170mm |
Handle | Φ32×170 |
Size of cutter | Blade replaceable |
Length of cable | 3M |
Outer skin | Aluminum |
Weight | 8KG |
Voltage | 220V / 110V |
Accessory | Foot switch1pc；Cut blade 25pcs；1.5mm special hex wrench 1pc；
Screw M3×4L 2pcs |
Material of cutter | titanium alloy, stainless steel |
Description:
Ultrasonic Cutting Machine is a class of device using ultrasonic
energy for cutting. Instead of using traditional blade
cutting,ultrasonic cutting has its advantages of smooth, reliable
cutting, accurate trimming, no deformation, no raising, fuzzing,
spinning,wrinkling etc. It can avoid the rough cutting-edge, coked
edge, fuzzballs and other shortcomings of laser cutting machine.
Ultrasonic cutting machine is used for cutting rubber, synthetic
fabric, cloth, plastic, sheet metal, food etc.
The cutting of food products using ultrasound is performed when an
ultrasonic blade comes into contact with the product to be cut,the
high vibration of 40,000 pulses per second, makes this product very
easily be cut even if it is of delicate or sticky texture
composition.
The much higher vibration does not allow any product to stick to
the blade. The cut is clean and without pressure on the product.
Typical materials processed
The difference between traditional cutting and ultrasonic cutting
Ultrasonic cutting machine is the use of wave energy for cutting
equipment, the main t feature is not to use the traditional edge.
The traditional cutting utilizes a tool with a sharp edge to press
the cutting material. The pressure is concentrated at the edge of
the blade, the pressure is very large, more than the shear strength
of the cutting material , then the material is cut open. As the
material is cut by a strong pressure, so the cutting tool edge
should be very sharp and the material itself has to bear the
relatively large pressure. Therefore the cutting effect for the
soft, flexible material is not good, especially more difficult for
sticky material.
Competitive Advantages
No special installation equipment
Smooth cutting of difficult-to-cut materials
Environment-friendly (No noise, no smoke, no air contamination)
Small hand-held size(can be attached to automotive machinery arms)
Cutting all kinds of ordinary tool to cut products, solve
production problems
Installation, easy to use, almost does not change the original
cutting process
Can use air-cooling, water-cooling design, adapt to various working
conditions and environment
Can be installed high hardness blade, cutting blade can be
replaced, greatly reducing the use cost
The use of high power ultrasonic transducer vibrating element,
ensure the long time stable working
The cutting speed is improved greatly, the efficiency 10 times
higher than the traditional cutting knife.
Cutting tool complete varieties, can also be customized according
to customer process shaped cutting tool
Can be used in the production of circular ultrasonic tool cutting
equipment, rolling cutting, suitable for cutting special
Product display:
