Automatic Eps Sandwich Panel Roll Forming Machine 0.3-0.6mm Sheet Thickne

equipment for the production sandwich panel eps roll forming machine

Manual Operation: Turn the Automatic Transfer Switch upon the Control Box to the Manual Operation, then the upper right of screen shows that the Manual Operation starts! At this moment,you can easily operate the upper cutter,the down cutter, pressing booster and the saw blade. Press the button that shows the upper cutter should forward, it starts working forward, now you can work the upper and lower blades (advance and retreat), and assist to push the pressing system,and the saw blades. touch the upper blade forward,then the blade began to walk forward, until the position of the down stroke switch stops. if you touch backward,it will began to walk backward,until the position of the up stroke switch stops. the lower blade is the same operation.
The operating of the down cutting is the same as the up cutting. Operation of the pressing material:click the button of the pressing material,the pressure plate is pressed down, and click the button again,the plate is released. Operation of Boosting: Press the button of Boosting, the long cylinder began to inflate, if the trolley is not in situ,the long cylinder will boost it to the place. Saw Blade:Click the button of Saw Blade, it will turn, and click it again,the saw blade will stop.

Current Maintenance
1.After the main machine shutting down, power off the glue pump immediately and dispose properly the glue tank to the glue storage. The glue tank should be cleaned after using it.
2.Loosen handle and hand wheel with compression function in view of after a long period of static pressure, abnormal repression and deformation will occur.
3.Check where glue passes, such as rubber wheels, rollers, hemming wheels, etc. If glue is found, remove it immediately.
4.Clean up the scrap materialof the vacuum system, knives, vacuum cleaners, storage bags and set aside.

Traditional color composite panels generally compound 10 cm thick white polystyrene foam insulation board, the insulation effect is not very good, because the thermal conductivity of polyphenyl foam board is relatively high (thermal conductivity 0.035W / (m · K) above), plus There is a gap between the foam board and the foam board, the leakage temperature is very serious, and the overall actual thermal conductivity is generally higher than 0.05.
New polyurethane spray insulation material can be directly sprayed on the color steel tile, its low thermal conductivity, only 0.022-0.024W / (m · K), insulation effect is 2-3 times that of polystyrene board, is currently all insulation materials in thermal insulation Especially excellent material. Because polyurethanes use direct spray forming technology in construction, the polyurethane foam layer does not form a complete seam impervious to water, which fundamentally eliminates the possibility of deep penetration of roof water along the seam. So as to play a anti-corrosion and waterproof effect.