Active Member
|
[China]
Address: 18F, Building 2, Nantai Yunchuanggu, Phoenix Community, Guangming District, Shenzhen, Guangdong, China
Contact name:Amy
Shenzhen FRIDA LCD Co., Ltd |
|
|
10.1 Inch Tft 1280x800 Lvds Interface 40 Pins Full Viewing Angle High Brightness
General Description:
R101B40-226-0101 power supply voltage is 3.3V,frame rate is 60Hz,clock frequency is 72.4MHz, the duration of rush current is about 2ms and rising time of Power Input is 1ms(min).
Specifications:
| Parameter | Specification | Unit |
| Active Area | 216.96(H)*135.6(V) | mm |
| Number Of Pixels | 1280(H)×800(V) | pixels |
| Pixel Pitch | 0.0565(H)×RGB×0.1695(V) | mm |
| Pixel Arrangement | Pixels RGB stripe arrangement | |
| Display Mode | Normally Black | |
| Display Colors | 16.7M(6bit +Hi-FRC) | colors |
| Surface Treatment | HC | |
| Contrast Ratio | 1000:1(typ.) | |
| Viewing Angle(CR>10) | 80/80/80/80(typ.) | |
| Response Time | 35(typ.)/40(max.) | ms |
| Color Gamut | 50%NTSC | |
| Power Consumption | Panel: 0.7(Typ.) | watt |
| Outline Dimension | 221.96(H)*144.43(V)*1.06(typ)(FOB -Panel) | mm |
Absolute Maximum Ratings:
| Parameter | Symbol | Min. | Max. | Unit | Remarks | |
Power Supply | LCD Module | VDD | VSS-0.3 | 3.6 | V | Ta = 25 ℃ |
| Operating Temperature | TOP | -20 | +70 | ℃ |
| |
| Storage Temperature | TST | -30 | +80 | ℃ | ||
| Operating Ambient Humidity | Hop | 10 | 90 | %RH | ||
| Storage Humidity | Hst | 10 | 90 | %RH | ||
Electrical Specifications:
Parameter | Symbol | Values | Unit | |||
| Min. | Typ. | Max. | ||||
Power Supply Voltage | VDD | 3.0 | 3.3 | 3.6 | V | |
| VRP | 300 | mV | ||||
| Power Supply Current | IDD | - | 212 | 364 | mA | |
| Power Consumption | PLCD | - | 0.7 | 1.2 | W | |
| Rush current | IRUSH | - | - | 3.0 | A | |
CMOS Interface | Input Voltage | VIH | 2.7 | 3.3 | V | |
| VIL | 0 | 0.5 | V | |||
Output Voltage | VOH | 2.7 | 3.3 | V | ||
| VOL | 0 | 0.5 | V | |||
Interface Connection:
| Pin No. | Symbol | Description | I/O |
| 1 | NC | Non Connection | - |
| 2 | VDDIN | Power supply VDDIN=3.3V (Typ.) | P |
| 3 | VDDIN | P | |
| 4 | VDDIN | P | |
| 5 | NC | Non Connection | - |
| 6 | GND | GROUND | P |
| 7 | GND | GROUND | P |
| 8 | RIN0- | LVDS Negative data signal (-) | I |
| 9 | RIN0+ | LVDS Positive data signal (+) | I |
| 10 | GND | GROUND | P |
| 11 | RIN1- | LVDS Negative data signal (-) | I |
| 12 | RIN1+ | LVDS Positive data signal (+) | I |
| 13 | GND | GROUND | P |
| 14 | RIN2- | LVDS Negative data signal (-) | I |
| 15 | RIN2+ | LVDS Positive data signal (+) | I |
| 16 | GND | GROUND | P |
| 17 | LVDS_CLK- | LVDS Negative CLK signal (-) | I |
| 18 | LVDS_CLK+ | LVDS Positive CLK signal (+) | I |
| 19 | GND | GROUND | P |
| 20 | RIN3- | LVDS Negative data signal (-) | I |
| 21 | RIN3+ | LVDS Positive data signal (+) | I |
| 22 | GND | GROUND | P |
| 23 | NC | Non Connection | - |
| 24 | NC | Non Connection | - |
| 25 | GND | GROUND | P |
| 26 | NC | Non Connection | - |
| 27 | NC | Non Connection | - |
| 28 | GND | GROUND | P |
| 29 | NC | Non Connection | - |
| 30 | NC | Non Connection | - |
| 31 | LED- | LED Cathode | O |
| 32 | LED- | O | |
| 33 | LED- | O | |
| 34 | NC | Non Connection | - |
| 35 | NC | Non Connection | - |
| 36 | NC | Non Connection | - |
| 37 | NC | Non Connection | - |
| 38 | LED+ | LED Anode | P |
39 | LED+ | P | |
| 40 | LED+ | P |
Optical Specification:
| Item | Symbol | Condition | Min | Typ. | Max | Unit |
Viewing Angle | θL | Cr≥10 | 70 | 80 | -- | deg |
| θR | 70 | 80 | -- | |||
| θT | 70 | 80 | -- | |||
| θB | 70 | 80 | -- | |||
| Contrast Ratio | Cr | θ=0° FF=0° | -- | 1000 | - | |
| Response Time | Tr+Tf | -- | 35 | 40 | ms | |
Color Coordinate of CIE1 931 | Rx | θ=0° | -- | - | ||
| Ry | -- | |||||
| Gx | -- | |||||
| Gy | -- | |||||
| Bx | -- | |||||
| By | -- | |||||
| Wx | -- | |||||
| Wy | -- | |||||
| NTSC Ratio | NTSC | CIE1931 | 45 | 50 | -- | % |
| Gamma | - | 1.9 | 2.2 | 2.5 | ||
| Polarization Direction of Front Polarizer | - | 0 | deg | |||
| Polarization Direction of Rear Polarizer | PdR | 90 | deg | |||
Handling Precautions:
1.Do not display the fixed pattern for a long time because it may develop image sticking due to the LCD structure. If the screen is displayed with fixed pattern, use a screen saver .
2.Do not store the LCD near organic solvents or corrosive gasses.
