Shoe Sole Milky Liquid Water Based Release Agent

                     Water Based Release Agent for Shoe Sole Slippers Polyurethane Systems PU TPU and Rubber

1. Product Description

Water Based Release Agent for Shoe Sole Slippers Polyurethane Systems PU TPU and Rubber
Chemical Composition:
The water based release agent for shoe Sole is made by special silicone oil, wax liquid and surfactant by special process.

2. Properties

3. Advantage

• Good mold release, no residue, no oil, long duration of mold release.
• It is not easy to pollute the mold, reduce The Times of cleaning the mold, and do not affect the second processing of the product, painting, pasting, oil screen printing process.
• Reduce the defect rate of molded products and improve the production efficiency.
• As it is a dry coating, it will not be transferred to the formed products, so there will be no viscosity on the formed products.
• It only needs to spray a thin layer on the mold to improve the accuracy and precision of the product appearance.

4. Application

• It it mainly used as mould release agent for three different polyurethane systems: PU, TPU & Rubber;
• It is widely used in the demoulding of upper and lower molds for all kinds of shoes materials;
• It has excellent release properties, anti-die carbon deposition performance, minimal influence on post-coating and bonding, and at the same time gives the product a low surface gloss, and has a relatively wide mold temperature of 60 ± 10 ° C

5. How to use

• Thoroughly clean the mold, especially need to remove the release agent and product residue, you can use a certain amount of washing water or alkali to soak the mold; after soaking, rinse the mold with solvent or water to completely remove the cleaning medium, especially alkaline substances; thoroughly dry
• Dilute the release agent in deionized water to the desired multiple (typically diluted to 20-30 times depending on the case)and spray with a high pressure spray gun.
• In general, it is recommended to use it in one spray and one demold form.

a) Clean well the mould
b) Mix with normal water before using, dilute ratio is 1:8-10
c) Mould temperature:40-60 degree
d) Spray using nozzle gun diam 0.3mm
e) Tank pressure 0.8-1 bar,air pressure 2.5 bar
f) Spray the release agent directly into the mould
g) After spray the release agent dry it with air, and clean by cotton