|
[China]
Trade Verify
Address: No.27 BOWANG Street ,Nan Cun Town, Panyu, Guangzhou, GD,China
Phone: 86-020-28991965
Contact name:Alice
Guang Zhou Sunland New Energy Technology Co., Ltd. |
|
Verified Suppliers
|
|
|
No.
| Item
| General Parameter
| Remark
|
| 1 | Rated Capacity
| 220.0Ah | Standard discharge(0.2 C5)after standard charge(0.2 C5)
|
| 2 | Minimal Rated Capacity
| 200.0Ah | |
| 3 | Nominal Voltage
| 12.8V | |
| 4 | Cycle Life
| Higher than 60% of the Initial Capacity of the Cells | ◆Charge: CC@0.2C to 14.6V, then CV till current to 0.05C ◆Rest: 30min. ◆Discharge: 0.2C to 10.0V ◆Temperature:20±5℃ ◆Carry out 2000cycles 100%DOD ◆Carry out 3000cycles 80%DOD ◆Carry out 3500cycles 60%DOD ◆ |
| 5 | Discharge cut-off voltage
| 10.0V |
|
| 6 | Charging cut-off voltage
| 15.6V |
|
| 7 | Cell and assembly method
| IFR26650EC-3.3AH | 4S66P |
| 8 | Housing material
| ABS+PC housing
|
1.Charge protection
When the Battery modules are charged to full, they will communicate with BMU, and the BMU has the capability to turn off the charger or open the main contactor. The battery module itself does not have any switch to disconnect the charger.
2.Balancing
The inter-module balancing circuit is used to compensate slight capacity imbalance between different battery modules in series connection.
3.State of Charge Measurement
Individual cell block voltage and charge/discharge current will be used to monitor the state of charge (SOC) of the battery module. The estimated capacity used for the calculations will be adjusted to meet the capacity of the lowest capacity cell block when the battery system is fully cycled. The state of charge will be adjusted for normal self discharge of the battery system when the unit is not on charge.
4.RS-485 Communication Uplink
RS-485 Communications will be used to communicate with the Battery Management Unit (BMU) or connection to other battery Modules.
5.RS-485 Communication Downlink
RS-485 Communication connection from Downstream battery module.
6.Status LED
A Dual LED on module to indicate working status. One is green and the other one is red. Blinking of the green LED indicates that the module is working properly. Blinking of the red LED indicates that the module has failure and needs service.
TAC can support capacity and voltage with standard module
the voltage from 3.7v to 72v
the capacity from 3300mah to 300ah
Our company approved by ISO and many model have passed IEC UL un38.3 Reach, BIS etc
Our Production Line
