Active Member
|
[China]
Address: Bldg. A, Xuesheng Industrial Area, Hongqiaotou Community, Songgang Street, Bao'an District, Shenzhen, China
Contact name:Peony Jin
Shenzhen ATA Technology Co., Ltd |
|
|
Safety Information
1. The SMD light ribbon itself and all its components may not be
mechanically stressed. Assembly must not damage or destroy
conducting paths on the circuit board.
2. Installation of LED light ribbon (with power supplies) needs to
be comply with all applicable electrical and safety standards. Only
qualified personnel should be allowed to perform installations.
Correct electrical polarity needs to be observed. Wrong polarity
may destroy the ribbon.
3. Parallel connection is highly recommended as safe electrical
operation mode.
4. Serial connection is not recommended. Unbalanced voltage drop
can cause hazardous overload and damage the ribbon.
5. Please ensure that the power supply is of adequate power to
operate the total load.
6. When mounting on metallic or otherwise conductive surfaces,
there needs to be an electrical insulated points between ribbon and
the mounting surface.
7. Please pay attention to standard ESD precautions when installing
the ribbon.
| Absolute Maximum Rating at TA=25°C | |||||
| Parameter | Symbol | Absolute Maximum Rating | Unit | ||
| ATA-NF60 | |||||
| Forward Current | IF | 2000 | mA | ||
| Forward Voltage | VF | DC 12 | V | ||
| Electrostatic Discharge | ESD | 400 | V | ||
| Operating Temperature | Topr | -25~+60 | °C | ||
| StorageTemperature | Tstg | -40~+80 | °C | ||
