mild steel black pipe , ERW pipe , Q235 / A53 gr. B welded pipe
General information of A53
Pipe ordered under this specification is intended for mechanical
and pressure applications and is also accept-able for ordinary uses
in steam, water, gas, and air lines. It is suitable for welding,
and suitable for forming operations involving coiling, bending, and
flanging, subject to the following qualifications:
|ERW Steel pipes||Welding Type ERW Electric Resistance Welding|
|Size||Outside Diameter : 60mm- 813mm|
API 5L, ASTM A252/A134, ASTM A106-2006, ASTM A213-2001,
ASTM A312- 2001, ASTM A53-2007, EN10217, EN10219BS EN
10255BS EN 10226BS 1387, BS 4568, GB/T3901GB/t9711.1-
|Wall thickness||2.mm to 25mm|
|Material||API Gr.B ASTM GR.A, GR.B, X42, X46, X52,etc|
|Certificates||API ISO TUV SGS BV etc|
Loose package, Or in bundles(3Ton Max) , bundled pipes with two
slings at the both end for easy loading and discharging,
|Surface Treatment||Bare :Rust-proof black painting or following client request|
Standard marking, or according to your request. Marking Method:
Spray white paint
|End treatment||Bevel End or Plain End|
Single Random Length and double Random Length.
SRL:5.8M DRL:11.8M or As clients requested length
|Delivery Time||10-40 days|
|Payment Term||TT, LC at sight, etc.|
|Fluid pipe Power Plant||Fluid pipe|
|Structure pipe||Structure pipe|
|High and low pressure Boiler tube||High and low pressure Boiler tube|
Seamless steel tubes for petroleum cracking Conduit pipe
Scaffolding pipe pharmaceutical and ship building etc.
|Seamless steel tubes for petroleum cracking Conduit pipeScaffolding pipe etc.|
|Main Market||Asia, Middle East, Europe, America, Africa, Australia, etc.|
| || |
1. The test specimens and the tests required by this specification
shall conform to those described in the latest issue of Test
Methods and Definitions A 370.
2. The longitudinal tension test specimen shall be taken from the
end of the pipe or, for continuous-welded pipe, it shall be
permissible to be taken from the skelp, ata point approximately 90°
from the weld, and shall not be flattened between gage marks. The
sides of each specimen shall be parallel between gage marks. If
desired, the tension tests are permitted to be made on the full
section of pipe. When impracticable to pull a test specimen in full
the standard 2-in. [50-mm] gage length tension test speci-men shown
in Fig. A2.3 of Test Methods and Definitions
A 370 is acceptable.
3. Transverse weld test specimens from electric-resistance-welded
pipe shall be taken with the weld at the center of the specimen.
All transverse test specimens shall be approximately 1 1⁄2in. [40
mm] wide in the gage length and shall represent the full wall
thickness of the pipe from which the specimen was cut.
4. Test specimens for the bend and flattening tests shall be taken
from pipe. Test specimens for the flattening test shall be smooth
on the ends and free from burrs.
5. All specimens shall be tested at room temperature.