Customized Stainless Steel Floor Drain For House Building And
Project Construction
Stainless steel floor drain selection points
- Water seal is one of the important features of water seal floor
drain. When selecting, you should know whether the water seal depth
of the product reaches 50mm. Side wall type floor drain, with frame
floor drain, closed type floor drain generally do not have water
seal; anti-overflow floor drain, multi-channel floor drain mostly
with water seal, should be clearly understood according to the
manufacturer's information when selecting.For drains without water
seal, the depth of the drain seal should be no less than 50mm. This
component can be configured by the floor drain manufacturer or by
the construction unit where the floor drain is installed.
- The height of the floor drain rafter can be adjusted, and the
height adjustment is not less than 35mm to ensure that the floor
drain surface level and the ground level after the ground
decoration is completed. The waterproof wing ring is provided for
the floor drain to ensure the waterproofing of the floor drain when
it is installed on the floor.The floor drain of an underground
garage car passage or a load-bearing place shall have the strength
of the rafter to meet the corresponding load.
- The structure of the drain with water seal should be reasonable and
smooth, and the debris in the drainage is not easy to settle; the
cross-sectional area of the cross section of each part should be
larger than the cross-sectional area of the discharge pipe, and
the minimum net width of the cross section of the flow channel
should not be less than 10mm.
- There are three ways to connect the floor drain: socket; thread;
clamp. The size of the connection port can be determined according
to the relevant regulations of the current country.
- Deodorant floor drain should be preferred, and floor drains should
not be provided where drainage is not required. The builders have
not set up a leak in the backwaters and must not be completed.
Stainless steel floor drain installation
First: Trim the reserved hole of the drainage to make it completely
coincide with the floor drain that was bought back, because the
reserved hole for drainage by the real estate agent when the house
is delivered is relatively large. Among them, the opening aperture
of the floor drain tweezers should be controlled between 6-8mm,
which can prevent the entry of hair, sludge, sand and other
contaminants;
Second: It should be grasped that the multi-channel floor drain
inlet is installed according to the actual situation. The
multi-channel floor drain is a floor drain with a multi-functional
joint that can accept (washer, bathtub, washing machine and floor
drain). This structure can solve the problem of requiring multiple
drainages for a sewer.
There are two ways to add a floor drain in a place where there is
no floor drain: one is to raise the ground and lay down the water
pipe; the other is to break through the floor and re-route the
water pipe.
Stainless steel floor drain basic introduction
- The floor drain is a drainage device connected to the ground and
the drainage pipe system.
- The special features of the floor drain: it excludes ground water,
water stains, solid objects, fibrous materials, hair, and easy
deposits.
- The main function of the floor drain: Odor-proof, anti-blocking,
anti-mite, anti-virus, anti-backwater, anti-dry (mainly refers to
water-sealed floor drain)
- The quality of the floor drain is mainly reviewed from four angles:
drainage speed, deodorization effect, easy cleaning, and no
mechanical durability.
About stainless steel floor drain
- The floor drain should have four characteristics: fast drainage,
anti-odor, anti-clogging, easy to clean.
- Floor drains, floor drains, as the name implies, are leaking, and
the single function of leaking the floor drain has not kept up with
the times.
- The floor drain not only has to be launched quickly, but the most
important thing is to prevent blockage. Otherwise, if it is old, it
will be infinite.
Our projects
