|
[China]
Trade Verify
Address: Room 101, 1st Floor, No. 6, Third Street, Pingshan Industrial Zone 511495, Shibi Street, Panyu District, Guangzhou, China
Contact name:Zoe Zou
Sinuo Testing Equipment Co. , Limited |
|
Verified Suppliers
|
|
|
BS EN 12983-1 Bottom Concavity Measurement Instrument For Measure The Concavity
Product Information For Bottom Concavity Measurement Instrument:
The Cookware Bottom Concavity Measurement Instrument complies with EN 12983-1:2020, annex Q.2.11. It is used to measure the concavity of the bottom of the pot (thermal shock deformation).
Technical Parameters For Bottom Concavity Measurement Instrument:
A. Dial indicator accuracy 0.01mm
B. Measuring diameter range φ100mm~φ300mm
C. Measuring support point:
For round bottom utensil: Measure two perpendicular diameters
For non-round bottom utensil: Measure the largest and the smallest diameter
D. Measuring point: A diameter of a circle of 10mm diameter centered on the bottom of the pot.
Test Procedures and Operation For Bottom Concavity Measurement Instrument:
A. Adjust the support foot to the diameter position and fix it, and, Set the dial indicator to zero when it is on a flat surface
B. The test device is placed in the pot to test the concavity of heating deformation.
Note: for non-pan, it is not necessary to set the dial indicator to zero in advance
