Active Member
|
[China]
Address: 2# Jinlong Rd. Baolong Industrial Zone, Longgang Dist. Shenzhen China 518000
Contact name:Tarik Lu
Force sensor torque transducer |
|
|
Single Point Load Cell 3kg 6kg 10kg 20kg 40kg High Accuracy Weight Sensor
High accuracy Single Point Load Cell FH03 is a strain gauge based weight transducer which offers 0-3kg / 0-6kg / 0-10kg / 0-20kg / 0-40kg five measuring ranges to choose from. Precision weighing sensor FH03 delivers maximum 0.015% non-linearity of the full capacity. Loadcell FH03 is corner trimmed for platform sizes up to 250x350mm which makes it suitable for off-center load measurement. Load Cell sensor FH03 delivers stable performance within the declared working temperature range thanks to its temperature compensation process. You may find Load cell transducer FH03 suitable for applications such as beehive weighing scales, packaging machines, platform scales, feeding machines and so on.
Specifications
| Rated capacity | 3kg / 30N / 6.6 lb 40kg / 400N / 88 lb | ||
| Sensitivity | 2.0 mV/V | Compensated temperature | -10...+40oC |
| Excitation | 3-15V | Operating temperature | -20...+60oC |
| Zero balance | ±0.1mV/V | Temperature shift zero | ±0.02% R.O./10oC |
| Nonlinearity | ±0.015% R.O. | Temperature shift span | ±0.02% R.O./10oC |
| Hysteresis | ±0.015% R.O. | Input resistance | 410±10 ohms |
| Nonrepeatability | ±0.01% R.O. | Output resistance | 350±5 ohms |
| Creep(30min) | ±0.02% R.O. | Insulation resistance | >5000Mohms |
| Safe overload | 150% F.S. | Ingress protection | IP65 |
| Ultimate overload | 200% F.S. | Material of element | Aluminum |
| Cable | Ø4*400mm 4-core shielded | ||
| Wiring code | Red--Power input+ Black--Power input- Green--Signal output+ White--Signal output- | ||
A weight sensor is a transducer that converts mechanical load into electrical signal which is proportional to the load being applied.The measured load or force causes deformation of the measuring element(elastic body),the bonded strain gauge deforms accordingly which will cause the resistance change of the wheatstone bridge,under constant power supply, the output signal between Sig+ and Sig- will change proportionally, thus the load/force can be measured by measuring the output signal from the load cell which is normally within 0-30mV for single point load cell FH03. Overloading is the most common cause of loadcell failure, a load sensor is just like a spring in certain aspects, which will be damaged if overstretched or overloaded. A machanical stop(refer to below picture) can be used to protect the sensor from excessive deformation. The deformation distance can be determined by loading the sensor with rated capacity, then adjust the meachnical stop to reach the bottom of the transducer. In most cases, the load cell will be used to measure load at 40-80% of the full capacity, thus the deformation distance can be adjusted using reference load a bit higher than the target load to be measured instead of the rated capacity.
Single Point Load Cell 3kg 6kg 10kg 20kg 40kg High Accuracy Weight Transducer
