|
[China]
Trade Verify
Address: No.265 of zhongshan road ,shijiazhuang city ,heibei province ,china 050000
Contact name:zhijing.gao
Huihao Hardware Mesh Product Limited |
|
Verified Suppliers
|
|
|
Capacitor Discharge (CD) Weld Pins are commonly used to attach blanket insulation to ducts,
ovens, boilers and hot or cold equipment.
The pins are welded in place, the insulation impaled over the pin and then self locking
washers are installed over the pin to secure the insulation.
Materal: Mild Steel
Finish: Zinc coated or copper plated
Washers: Self-locking washers are available in a variety of sizes, shapes, and materials.
Pin Dia: 12GA Or 10GA
Flange Size: 0.165" Or 0.188"
Flange Height: 4mm
Length: 1/2"-10"
 | D | FD Width | FD Height | L |
| 12GA(0.105") | 0.165" | 4mm | 1/2"-8" | |
| 10GA(0.135") | 0.188" | 4mm | 1"-10" |
 | Copper Coated Mild Steel Conical Tip CD Weld Pins Pin Diameter: 12GA Pin Length:1/2"-8" Flange Width:0.165" Flange Height: 4mm Pin Diameter:10GA Pin Length:1"-10" Flange Width:0.188" Flange Height:4mm |
 | Galvanized Steel Conical Tip Capacitor Discharge (CD) Weld Pins Pin Diameter: 12GA Pin Length:1/2"-8" Flange Width:0.165" Flange Height: 4mm Pin Diameter:10GA Pin Length:1"-10" Flange Width:0.188" Flange Height:4mm |
Materal: Aluminum Alloy 1100-H14
Washers: Self-locking washers are available in a variety of sizes, shapes, and materials.
Pin Dia: 12GA Or 10GA
Flange Size: 0.220" Or 0.250"
| Size | D | FD | L |
| 12GA | 0.105" | 0.220" | As Your Request | |
| 10GA | 0.135" | 0.250" | As Your Request |
 | Aluminum Alloy 1100-H14 Conical Tip Capacitor Discharge (CD) Weld
Pins Pin Diameter: 12GA Pin Length:1/2"-8" Flange Width:0.165" Flange Height: 4mm Pin Diameter:10GA Pin Length:1"-10" Flange Width:0.188" Flange Height:4mm |
the standard, portable CD system consists of:
> The Controller or (Power Unit) which is plugged into the one-hundred-and-ten-volt outlet.
> The CD Gun with Cables is used to command the power unit and deliver weld current,
with the Gun also serving as the Pin holder to properly place the pin during welding.
> Then, on the other side of “the circuit” a ground cable and clamping connection is
attached to the work-surface to complete our Capacitor Discharge connections.
> And finally, special Accessories are used to hold the Pin in the Gun.
