Sl62 Sl72 Australian Standards Reinforcement Wire Mesh Diameter 6mm 8mm 10mm

SL62 SL72 Australian Standards Diameter 6mm 8mm 10mm Reinforcement Wire Mesh

Concrete Reinforcing Mesh also known as steel reinforcing mesh, welded wire fabric, ribbed steel bars welded mesh and so on. Be made from cold reduced Wire or cold rolled ribbed bar, It is in the same or different diameters of the vertical and horizontal steel bars , and has a rectangular or square apertures and is produced in flat sheets. It is used to provide tensile strength and crack control to structural concrete elements.

The construction of the reinforcement mesh is made of high-quality low-carbon steel wire, cold-rolled ribbed steel bars or cold-rolled round steel bars for stainless steel wire at right angles to the longitudinal and transverse directions, and all are inserted through the electric welding according to a certain distance. Beforehand, the greasy surface, paint stain, cement slurry and floating skin and rust etc. of the steel bar should be clear and clean. After the processing is completed, the reinforced mesh should be flat, and the surface of the reinforced steel should not be damaged by weakening the cross-section of the reinforced steel. Straighten the steel bar first, and then cut it into steel bars. The scale of the reinforced mesh is summarized and considered according to the distance between the arch and the degree of overlap between the mesh.

packing: