|
[China]
Trade Verify
Address: Bairong Road and Xingyuan Road, Erqi District, Zhengzhou city, China
Contact name:Thomas Wang
HENAN TMS MACHINERY CO., LTD |
|
Verified Suppliers
|
|
|
380 V Scrap Metal Processing Equipment Scrap Copper Wire Granulator 99.9% Copper Purity
Brief Introduction of copper recycling machine
400 Copper recycling machine is used for handling automobile wires, communication cables and other types of miscellaneous wires and cables. This machine has a compact structure, and shows stable and reliable performance. Scrap copper wires and cables are chopped by the Chopper in the machine and then plastic pieces and copper granules are separated by airflow and vibration. Copper granules and plastic pieces come out of the machine through different outlets, and dust is collected by Dust Collector.
(Copper wires less than 20mm in diameter are suitable; single conductor with diameter of 0.2-0.3mm is best.). If the diameter of cables is more than 20mm and less than 40mm, the large model TMS-800 and 1000 are best choice for you.
Technical specifications of copper recycling machine
| Equipment Components | Chopper | Motor Power: 15kw Rotating Blade Quantity: 8 Quantity of Fixed Blades: 4 Screen Size: Φ3mm / Φ4mm Spindle speed: 900r/min |
| High pressure fan | 3kw | |
| Separator | Vibration Motor: 0.18kw (2 Units) Vibration: Frequency Regulation | |
| Bottom Blower Fan | Fan Power: 2.2 kw Filter: Φ280 * 1000 Air Volume Control: electric control panel on the electric control box | |
| Upper Suction Fan | Fan power: 2.2 kw Material Collecting Mode: Cyclone Dust Collector Collecting Bag: 1 Dust bag: 1 | |
| Small shaking table | 0.18 kw*2sets |
Machine features of copper recycling machine
1. The whole system is controlled by the Electricity Control Panel.
2. The operation is stable.
3. Minimum copper recovery rate can reach 99%.
4. Small area occupy and save labour.
Materials processed of copper recycling machine
The choice of a copper recycling machine depends on the material
properties of the types of copper wires and cables. Correct choice
can not only improve the working efficiency, but also extend the
service life of the machine. The cutting blades are made with Wire
Cutting Technique, blades are replaceable for each other. We have
different requirements for blades to different types of copper
wires.
1). Air-fine Wires, Multi-strands
When dealing with Air-fine Wires and Multi-strands fixed blades and rotating blades must be very sharp so that copper wires can be cut and copper granules will be very clean and pure.
2). Single-strand and Single-core Wires
When dealing with Single-strand and Single-core Wires, the rotating blades shall be a little blunt and fixed blades must be sharp. In this case, the spacing between the rotating blades and fixed blades is just able to hold wires but does not touch the cores. The wires are crushed but there will be little copper granules with plastics outside.
(Note: if blades are not adjusted in accordance with the requirements, it may cause too many copper clad granules and the separation is not clean, etc.)
