GI Steel 1.2 - 2.0mm Stud Roll Forming Machine Used For Light Steel Stud and Track

 
Working flow:
 
Cantilever decoiler----feeding----rollforming----straightening----hydraulic cutting----run out table
 

 
Packing Pic
 


Roll forming main machine
 

• Roll station: 18stations
• Material of roller: Cr45 steel, polished and coated with chrome
• Material of main shaft:45﹟forge steel diameter roller: Ф 85mm
• Main power: 7.5KW machine
• Transmission: by single Chains 1.2 inch
• Feeding and guide: surface polished and coated with chrome
• Machine adopt protect cover
• Machine adopt new station with chrome (at the up of each station have dial)
• Size of machine:10000x1600x1200(mm) L x W x H need 1x40GP container
• Weight: about 6500Kgs
• Color of machine: blue
• Machine should be with four legs (made from metal) in 350mm
• Motorized Pre-cutting: It is used when changing the coil of raw material; it can
• Cut the coil rapidly and time-saving.
• Cutting:

(1) Motorized Pre-cutting: It is used when changing the coil of raw material; it can
cut the coil rapidly and time-saving.
(2) Hydraulic Cutting after forming: Cut the sheet after roll forming to required
length
(3) Cutting motion: The main machine automatically stops and the cutting will take
place. After the cutting, the main machine will automatically start.
(4) Material of blade: CR12with heat treatment
(5) Length measuring: Automatic length measuring
(6) Tolerance of length: 3m+/- 1.5mm
 
Control panel Panasonic
 

• Voltage, Frequency, Phase: 380 V, 50 Hz, 3Phase
• Automatic length measurement
• Automatic quantity measurement
• Computer used to control length & quantity. Machine will automatically cut to length and stop when required quantity is achieved
• Length inaccuracy can be amended easily.
• Control panel: Button-type switch and touch screen
• Unit of length: millimeter (switched on the control panel)