CE certified concrete pp mesh fiber, Polypropylene fiber mesh form
INTRODUCTION:
Briture PP fiber is made of 100% virgin homopolymer polypropylene
with form of mesh , it is mainly used for concrete and motar
reinforcement, anti-cracking.
FUNCTION:
- Increase seepage resistance
- Prolong endurance
- Improve steel protection
- Increase cracking resistance
- Increase fire resistance
- Strengthen spurt & fatigue
- Improve tensile, bending & folding strength
- Improve plastic deformity
- Strong acid & alkali resistance and good endurance
SPECIFICATION:
| Maerial | 100% virgin polypropylene |
| Density(g/cm3) | 0.91 |
| Elastic Modulas (MPa) | 3500Mpa min. |
| Width (mm) | 5mm |
| Thickness (mm) | 0.035 |
| Length(mm) | 12,18,20... |
| Equivalent diameter (um) | 100 |
| Shape | beam-like Net |
| Crack elongation (%) | 10%min |
| Acid &Alkali Resistance | Strong |
| Water-absorbency | No. |
| Tensile strength (Mpa) | 560Mpa min. |
| Melting point (℃) | 160
|
APPLYING INSTRUCTION:
- Length : Generally, the proper length of the fiber added into
concrete is 20 mm, and in the spray concrete is 10mm.
- Ratio Design: Usually the proper amount of fiber to concrete is
0.9kg/m3 , and the water-proof layer of the bridge requires
1.35-1.8kg/m3, and the spray concrete in the tunnel is also the
same and other materials remain the same. The ratio of fiber and
concrete can be determined by tests for special purposes. The fiber
has better effects on the concrete with active compound materials,
such as silicon ash, coal powder, ground slag and zeolite powder.
- Mixer Adoption: Double-axle horizontal compelling mixer is better
and self-dropping cylinder mixer can be used, too.
- Mixing Process: Crushed stones, fibers and sands are put into the
mixer in succession. After stirring for two minutes, fiber will
fully spread and then add cement and water and stir normally. The
addition of materials also can be put into as usual, but the
stirring time should be properly prolonged to make fiber completely
mixed.
- Stirring Time: The purpose of the stirring is to make fiber fully
spread into monofilament or the net fully spread, so generally the
stirring time is 2-3minutes after the addition of polypropylene
fiber-mesh.
SUITABLE PROJECT:
- Be suitable for the water–proof layer, floor, inner &outer wall
of industrial and civil construction.
- Increase cracking resistance on the surface of industrial workshop,
warehouse and parking lot.
- Increase cracking & seepage resistance of the ground in
natatorium, swimming pool, pond and ditch. D). Be suitable for any
mortar projects and fine aggregate concrete projects.
